Best sellers
In stock
The thermal spacer insulates the carburetor from engine heat, thereby limiting "vapor lock" issues.
Spacer specifications:
Mounting hole spacing: 59mm
Mounting hole diameter: Ø 8.4mm
Inner diameter: Ø 32mm
Thickness:...
In stock
In stock
Photo 2 shows the fabric finish (off-white, diamond-point finish)
The part near the sun visors is made of hardboard.
The mounting ribs from your old headliner should be kept.
In stock
In stock
In stock
Suitable for:
Box 352
Box 365-00 / 365-02 / 365-05
Box 365-10 / 365-14 / 365-20 / 365-24 /365-28 / 365-29 - 365-33
Box 395
In stock
In stock
R8G / A110 (Engine 1255cc or1296cc ) Centering pins to be removed
R5 Alpine (R1223)
R5 Alpine Turbo (R122B)
In stock
For 5-speed gearbox (Type 353)
Overall length: 198cm
Sheath length 1: 85.5cm
Sheath length 2: 82.5cm
Cable length: 195cm
Cable end diameter: Ø 14mm
Our cables are made in France and meet the assembly and quality...
In stock
Distance between two pulley mounting screws: 30mm
Pulley is secured using 3 M7 screws (not supplied)
The heater outlets can be plugged using two 16mm diameter rubber plugs and one 10mm diameter plug
Water pump sold...
Out of stock
Suspension ball joints: M12x125 axle - Cone Ø 12.50mm to Ø 14mm
Mounting center distance on the wishbone: 42mm and 51mm
Renault OE Ref: 7701450635 / 7701461161
In stock
Fuel pump with priming lever
Inlet and outlet pipe diameter: Ø 6mm
Supplied with a paper gasket
Suitable for Gordini engines (1108cc / 1255cc and 1296cc – Type 804 and 812):
R8 Gordini
A110 1100G / 1300G and 1300S...
Out of stock
Out of stock
To turn on a temperature warning light
Trigger temperature 97°C
Out of stock
The supplied ring allows the Ø 17x5x10mm bearing to be installed on the rack and pinion gears
In stock
In stock
Pair of pivots sold with:
x2 Pivot axles with silent blocks
x4 Bronze Rings
x2 Rubber Dust Covers
x2 Nylon washers
In stock
Suitable for:
R8 / A110: Rear Brake (Big Brake Mounting Type)
A310.4 (All Models): Rear Brake
A310.6 (Before 1980): Rear Brake
In stock
In stock
This brake limiter replaces the original non-adjustable rear brake proportioning valve.
The limiter is not load-dependent (it does not vary according to the vehicle's load).
Its adjustment is manual, using the...
In stock
Out of stock
Overall length: 271 cm
Cable length: 271 cm
CableØ 2 mm
Sold without sheath, compatible with original cable sheaths
Our cables are made in France and meet the assembly and quality standards of original equipment...
In stock
In stock
In stock
In stock
Out of stock
In stock
Come with x3 aviation brake hoses to replace copper pipes
In stock
Kit of 2 rubber heating hoses "Sofica" under the dashboard - Ref 6000000556 + 6000000561 +6000000562
A hose needs to be cut at the location of the heating tap.
In stock
In stock
Suitable for:
R8 / A110 : Rear Brake (Big Brake Type Mounting)
A310.4 (All Models) : Rear Brake
A310 V6 (Before 1980) : Rear Brake
In stock
Head gasket with oblong holes
Suitable for engines:
1108cc engine: Type 688-02 / 688-06 / 688-09 (R8S R1136)
956cc engine: Type 689-01 / 689-03
In stock
In stock
In stock
For mounting the oil pressure sender (AVP4079) on the R5 alpine engine
In stock
In stock
For tightening the oil filter plate on the engine block
In stock
Water temperature sensor for Simca 1000 with temperature display on a dashboard needle gauge (From 1977 onwards)
Sensor diameter: M14 - 1.25 thread pitch
Connector: 6.3mm wide spade terminal
Wrench size: 16
In stock
In stock
Mounting center distance: 60mm
Fuel banjo bolt diameter: M12x100
Suitable for vehicles:
A110 1600 SX (VD) and SC (VH)
A310.4: All models
Out of stock
In stock
In stock
Overall length: 271cm
Sheath length: 87cm
Cable length: 268cm
Cable Ø 1.5mm
Our cables are made in France and meet the assembly and quality standards of original equipment (OEM) cables from automotive manufacturers.
In stock
In stock
Suspension ball joints: M12x125 axle - Cone Ø 12.50mm to Ø 14mm
Mounting center distance on the wishbone: 42mm and 51mm
OE Renault Ref: 7701450637 / 7701461162
In stock
In stock
In stock
In stock
Fitting dimensions:
Master cylinder side (Male thread): M16x150
Copper pipe fitting side (Female thread): Ø 1/2"-20 UNF (Ø 12.70mm)
In stock
In stock
Suitable for:
R8 / R8G / A110 : Front or rear disc (Big brake assembly)
A110 1600 SX (VH) : Front or rear disc
R16 (L / TL / TS) / R16TX : Front disc
A310.4 (No. 910 at the end of the series): Front disc
A310 V6 -...
In stock
Male / female connection: 3/8" - 24UNF
In stock
In stock
Overall Length: 162cm x 2
Sheath Length: 146cm x 2
Cable Length: 159cm x 2
Our cables are made in France and meet the assembly and quality standards of original equipment (OEM) cables from automotive manufacturers.
In stock
In stock
Inner diameter: 145mm
Outer diameter: 180mm
Height: 27mm
With top mounting clips
Sold individually
In stock
Stud diameter: M7
Stud length (overall): 40mm
Sold individually, 6 studs required per cylinder head
Renault OE part number: 6000004793
In stock