Water pump (1600cc engine) - Pulley mounting hole spacing 30mm

Reference:

6074

Distance between two pulley mounting screws: 30mm
Pulley is secured using 3 M7 screws (not supplied)
The heater outlets can be plugged using two 16mm diameter rubber plugs and one 10mm diameter plug
Water pump sold with water pump gasket, plate gasket, bleed plate, and bleed screw

You may also like

Reference: 6250

€17.00 (tax incl.)

In stock

Reference: 6208-16

€1.00 (tax incl.)

In stock

Reference: 6208-10

€1.00 (tax incl.)

In stock

Reference: 6076

€5.00 (tax incl.)

In stock

Reference: 6077

€4.00 (tax incl.)

In stock

Customers who bought this product also bought:

Reference: 1108

€0.50 (tax incl.)

In stock

Reference: 6904

€13.50 (tax incl.)

In stock

Reference: 6309

€13.00 (tax incl.)

In stock

This kit contains an M9 adjustment screw nut and an M8 nut.
Kit sold with a strong Ø 38mm square gasket and a weak Ø 38mm gasket.
The supply of these two seals allows you to install the most suitable seal depending on the wear of the caliper grooves.
To identify a caliper with a square or round seal, refer to the symbol indicated on the caliper casting.
A square symbol indicates a square seal, while a circle symbol indicates a round seal.
It is essential to replace the same type of seal (round or square) according to the symbol on the caliper.
We recommend checking the symbol displayed on each caliper, as a vehicle may have Calipers of different origins, some of which may have square joints and others round joints.
It is not recommended to mix calipers on the same set, as this can lead to the risk of skewing during braking.