Best sellers
Lock cylinder supplied with key and duplicate (2 keys per cylinder)
Overall length of the cylinder: 28mm
Length from the head to the fixing point: 23mm
Cylinder head diameter: Ø 15.20mm
Cylinder diameter: Ø 12mm...
In stock
In stock
Thick Washer M12
Washer Outer Diameter: Ø 35mm
Washer Thickness: 4.5mm
Sold individually
Original Renault / Alpine OE Ref (Tie) : 6075910 / 0607591000
Renault OE Ref (Screw) : 7703053072
In stock
Overall length: 23 cm
Fixed to the door with two screws
In stock
Kit includes: 4 screws, 8 washers, and 4 nuts
This kit allows you to install an aluminum shim on the pivot (right or left),
2 kits required per vehicle.
In stock
In stock
Lower mounting eye width: 21mm
Lower mounting eye inner diameter: Ø 9mm
In stock
Overall length: 162.5cm
Sheath length: 144cm
Cable length: 156cm
Our cables are made in France and meet the assembly and quality standards of original equipment (OEM) cables from automotive manufacturers.
In stock
4L: R1123/ R1125 / R1129 / R2106 / R2391 / R2392 from 1976 to 1982
4L: R1123 / R 2106 / R2391 after 1983
In stock
Ball joint: M10x125 axle - Cone Ø 11.60mm to Ø 13mm
Center distance between wishbone mounting: 42mm and 48mm
Ball joint mounting diameter: 38mm
Renault OE Ref: 0996064400
Suitable for:
R16 TS (R1151): From start to...
In stock
Suitable for:
Simca Coupé 1000: Disc brake
Simca 1200S (Before 1970) / CG: Disc brake
Bearing dimensions: Ø 27x50.3x14.2mm and Ø 17.45x39.9x14.55mm
Oil seal dimensions: Ø 38x52x8mm
In stock
In stock
In stock
This harness uses the color codes of the original wires and terminals
Harness sold with installation plan, all connectors are identified and labeled
Harness for mounting with original terminal boxes or modern fuse...
In stock
In stock
Bulb holders with sockets sold as a pair: Right + Left
Sold without bulbs
Out of stock
Possible mounting on the 4CV / Dauphine and Dauphine Gordini cylinder head (aligned or offset mounting holes)
Intake manifold inner diameter: Ø 29mm
Exhaust manifold inner diameter: Ø 29mm
Outlet inner diameter: Ø...
Out of stock
Upright height: 30cm
Sold individually
In stock
Overall length: 23 cm
Fixed to the door with two screws
Out of stock
To be installed with a straight grease nipple M6x100 (AVP C107)
Specific screw: M12x150 (Fine Pitch)
OE Renault Ref: 8546170 / 0854617000
In stock
ATTENTION: straight, non-offset bracket for mounting a Bendix-type "big brake" caliper bracket
Brake bracket mounting hole spacing: 100mm
Original Alpine part number: 6000001437
Fixing with AVP4300 screws...
In stock
In stock
Suitable for WEBER DCOE 40 and DCOE 45 carburetors
Free spring length: 59mm
Wire diameter: Ø 0.4mm
Original Weber part number: 47600.064
Number 60 on the exploded view
In stock
Delivered without fuses
Dimensions: Lg 122mm x W 47mm x H 27mm - Fixing distance: 90mm
In stock
In stock
In stock
Master cylinder inner diameter: Ø 19.05mm
Outlet diameters (x4): Ø 10x100 (x3) and Ø 12x100 (x1)
Renault OE part number: 7700590483 / 7700638947 / 7701348924
Suitable for:
R16 TL (R1152): 2nd model
R16 TX / TL...
In stock
In stock
Suitable for:
R4 (R1120) from start to No. 954000
R4 (R1123) from start to No. 627131
R4 (R2106) from start to #24876
In stock
Wheel cylinder specifications:
Inner diameter: Ø 20.6 mm
Mounting screw diameter: M6 (2 holes)
Mounting hole spacing: 31 mm
Wheel cylinder body width (overall): 56 mm
Hose connection diameter: Ø 3/8 - 24 UNF
Hose...
In stock
In stock
In stock
In stock
Out of stock
The sets are supplied with the following components:
Liners (x4)
Domed Pistons (x4)
Rings (x12)
Pin (x4)
Circle clips (x8)
Dimensions of the different parts:
Liner bore diameter: Ø 77mm
Liner flange or top...
In stock
Overall length: 403 cm
Casing length: 395 cm
Cable length: 403 cm
Our cables are manufactured in France and meet the assembly and quality standards of original equipment (OEM) cables used by vehicle manufacturers.
In stock
Overall length: 156.5cm
Sheath length: 149cm
Cable length: 156.5cm
Cable with screw-on end in the speedometer
Renault OE Ref: 7700556572 / 7700562177 / 7701348392
Suitable for:
R5 Alpine (R1223): From...
In stock
- Cold-start water temperature sensor thread: M14x1.25
We recommend checking the sensors currently installed on your vehicle beforehand.
In stock
These twin-tube hydraulic shock absorbers are designed for versatile use, including road and rally driving.
With a firmer damping than conventional shock absorbers, these are perfect for sportier driving, while still...
In stock
In stock
Pair of pivots sold with:
x2 Pivot axles with clamps
x4 Bronze bushings
x2 Rubber dust caps
x2 Nylon washers
This is an exchange product. Please contact us and return your old ones. pivots (no screws in good...
In stock
This ignition harness consists of 4 spark plug wires and 1 coil wire, each 7mm in diameter.
It does not have interference suppression.
If the vehicle is equipped with sensitive electronic accessories, such as a...
In stock
Sold in 1ml lengths
In stock
In stock
This deflector is suitable for all wiper arms with flat blades, 5 or 6mm wide and 2.5mm thick (before 1970)
This accessory allows for better grip of the blades against the windshield while driving, and provides a...
In stock
Skate Dimensions: Height 54.5mm - Width 45.5mm (Diagonal Shape)
In stock
In stock
Grease nipple with steel ball
Grease nipple (overall) height: 18mm
Grease nipple with a 9 key
In stock
Grease nipple with steel ball
Grease nipple (overall) height: 25mm
Grease nipple with an 11mm key
In stock
Bulb for long-range
Single-pin base
Dimensions: 24X62.5mm
Part Number: 0855829500
Due to the many different bulb types used, please check compatibility with your vehicle.
In stock
Sheet Dimensions: Length 50cm x Width 33cm
Sheet Thickness: 3mm
Ideal for making oil pan gaskets, timing case gaskets, and cylinder head cover gaskets. These gaskets must be installed with a light clamping force....
In stock
Suitable for WEBER 40DCOE carburetors (First and last generation)
This spacer fills the gap between the 4.5 venturi outlet and the carburetor body.
It allows the installation of screw-on aluminum velocity stacks...
Out of stock
Air intake trumpet/trumpet for WEBER 45DCOE carburetor,
Protrusion length from the carburetor: 62mm,
ATTENTION: Must be mounted with venturi REF 48086,
Mounting kit REF 48098,
Suitable for mounting AVP filters ref...
In stock
In stock
Connectors : M12X100 (x2) and in M10x100 (x2)
In stock
Thickness: 1.7mm (repair side)
Oblong “Lunules” type cylinder head gasket.
In stock
In stock
It is recommended to perform a dry fit of all body components to ensure proper alignment. Adjustments may be necessary.
Shipping available. Contact us to obtain a transport quote and find out our conditions....
In stock
In stock