Kit of 16 valve spring washers (1400cm³ engine) - Ref 7703053261 (8 pieces) and Ref 7703053158 (8 pieces)

Suitable for:

• R5
• R5 Alpine Atmo (1223) and Alpine Turbo (122B)
• R12 (All models)
• R15
• R18

For DBA (Bendix) or Girling mounting

Segment Characteristics:

• • Segment Diameter: Ø 75.70mm
  • Thickness of Upper Segments (Fire-resistant): 1.75mm
  • Thickness of Intermediate Segments (Waterproof): 2mm
  • Low ring thickness (Scraper):4mm

It is essential to check the ring end gap of each ring before installing them on the pistons, according to the values ​​given by the manufacturer or in the supplied instructions.or the values ​​provided in the instruction manual.

During installation, the ring end gap must be evenly distributed around the piston circumference at 120°.

Bearing Dimensions:

• Dimension: Original (Standard) Dimension
• Crankpin Diameter (A): Ø 43.98mm
• Housing Diameter (B): Ø 47.62mm
• Bearing Width (C): 20.75mm
• Bearing Thickness (D): 1.81mm
• Smooth, lug-type bearings with no grease holes or grooves
• Bearing Material: Bimetal

Replaces Ducellier 582012

• Single chain: x58 links
• Crankshaft sprocket x17 teeth and camshaft sprocket x34 teeth
• Oil seal: Ø 35x50x8mm
• Timing cover gasket: Cork and rubber

Compatible with :

• R8G R1134 (1108cm³ engine - Type 804) / R1135 (1255cm³ and 1296cm³ engine - Type 812)
• Alpine A110 1108cm³ / 1289cm³ (V85) / 1300G / 1300S
• R5 Turbo 1 and 2 (1397cm³)
• R12.TS (1289cm³)

• This hose kit can be fitted to both front (Ø 48mm) and rear (Ø 48mm) calipers with a hydraulic handbrake, provided the banjo bolts on the rear brake fittings are replaced with two Ø 3/8"-24UNF bolts (Length under head 25mm).
• The kit comes with two Ø 3/8"-24UNF banjo bolts (Ø 9.52mm) and two Ø 10x125 banjo bolts.