Lower wishbone axle washer Ø 14.7x31.7x3mm - Ref 7062174

• Inner diameter of the rubber washer: Ø 95mm
• Outer diameter of the rubber washer: Ø 125mm

Brake Disc Specifications:

• Outer Diameter: Ø 260mm
• Inner Centering Diameter: Ø 60mm
• Mounting Hole Spacing: 71mm
• Disc Offset: 33.5mm
• Brake Disc Thickness: 7.5mm (Solid Disc)
• Sold in pairs (2 discs)

Important: Brake discs have a specific mounting direction that must be observed. They are not interchangeable.

Installation direction of a solid, non-ventilated brake disc: The discs must be installed so that the edge of the grooves closest to the outer edge of the disc makes contact with the brake pad first.

For competition use only; do not use these discs on public roads.

• End cap for stop switch Ø 12.5mm
• Mounting using a long rod

• This kit contains an M9 adjustment screw nut and an M8 nut.
• Kit sold with a strong Ø 38mm square gasket and a weak Ø 38mm gasket.
• The supply of these two seals allows you to install the most suitable seal depending on the wear of the caliper grooves.
• To identify a caliper with a square or round seal, refer to the symbol indicated on the caliper casting.
• A square symbol indicates a square seal, while a circle symbol indicates a round seal.
• It is essential to replace the same type of seal (round or square) according to the symbol on the caliper.
• We recommend checking the symbol displayed on each caliper, as a vehicle may have Calipers of different origins, some of which may have square joints and others round joints.
• It is not recommended to mix calipers on the same set, as this can lead to the risk of skewing during braking.