Pair of "Intermediate setting" front shock absorbers - R8.G / Alpine A110 (all models)

Suitable for:

• R5 / R18 / R21 / R25 / R30 / : Rear Brake
• R8: Rear Big Brake Installation
• R5 Alpine Turbo (122B): Rear Brake
• R12G / R17G: Rear Brake
• A110: Rear Big Brake Installation
• A310.4: Rear Brake
• A310 V6 (Pre-1980): Rear Brake

Brake pads with a retaining stop (B in the diagram) must be installed with this stop facing forward (in the direction of wheel rotation)

4CV: Drum brake (From 06/1953 until end of series)

Alpine A106: Drum brake

Dauphine (All models): Disc brake

Caravelle / Florida: Disc brake

R10 / R8 (All models): Disc brake

Alpine A110 and GT4: Disc brake

Matradjet: Disc brake 

This kit contains x4 hoses Ø 3/8"-24UNF - Length of hoses 32cm and 26cm

• This kit contains an M9 adjustment screw nut and an M8 nut.
• Kit sold with a strong Ø 38mm square gasket and a weak Ø 38mm gasket.
• The supply of these two seals allows you to install the most suitable seal depending on the wear of the caliper grooves.
• To identify a caliper with a square or round seal, refer to the symbol indicated on the caliper casting.
• A square symbol indicates a square seal, while a circle symbol indicates a round seal.
• It is essential to replace the same type of seal (round or square) according to the symbol on the caliper.
• We recommend checking the symbol displayed on each caliper, as a vehicle may have Calipers of different origins, some of which may have square joints and others round joints.
• It is not recommended to mix calipers on the same set, as this can lead to the risk of skewing during braking.