O-ring alone for aluminum purge tee reference 8208

• Special Premium Quality graphite for clutch release bearings
• Important: The release bearing clamping screw must be placed on the side opposite the fork
• Depending on the diameter of the return spring, it may be necessary to re-drill the release bearing mounting.
• It is recommended to soak the release bearing in warm engine oil and then wipe it dry before installation to avoid squeaking noises

Suitable for vehicles:

• R8 and R8G: Rear Tank
• R10: Rear Tank
• Floride S and Caravelle Coupe only (R1131): Rear Tank (Capacity 31L)
• A110: Front Tank in Manolene (Plastic)

Fuel gauge equipped with a flat terminal.

• Renault OE Ref: 8552444 / 0855244400

Length 70mm

Ø70mm and Ø55mm

Brass scabbard that replaces the original plastic one.