In stock
Best sellers
- Sold complete with support, brass cap, insert and rubber teat
- Jar mounted with rubber teat Ø 6mm
In stock
In stock
Compatible with versions:
Alpine A110 SC / Si (1600VD)
Alpine A110 SX (1600VH)
In stock
In stock
In stock
Bearing Dimensions:
Dimension: Repair dimension (+0.25)
Junnel Diameter (A): Ø 54.55mm
Housing Diameter (B): Ø 58.75mm
Bearing Width (C): 19.50mm
Bearing Thickness (D): 2.07mm
Smooth, lug-type bearings with grease...
In stock
In stock
Out of stock
OE Renault Part Numbers: 7701068742 / 7701045747 / 7701020246 / 7701020006 / 7701017438 / 7701348081
Suitable for:
R5 (All models): For Ducellier, SEV Marchal, or Bosch mounting
R16 (R1156): TX / TL / TS
Simca 1200S
In stock
Out of stock
For engine with water pump, x4 outlets.
Kit sold without valve stem seals (AVP1012), without copper base seals and without the timing case oil seal (AVP1029).
Out of stock
Suitable for Simca 100 sedan / Coupé 1000 / 1200S from 1963 to 1969.
Ref: 29719F
In stock
Compatible with Ducellier igniters with an inner body diameter of Ø 58.8mm
WARNING: Not suitable for igniters with externally adjustable contact breakers (different plate attachment points)
Supplied with 3 screws for...
In stock
For the Alpine A108: Consult us before placing the order because several assemblies are possible.
In stock
In stock
Center distance of the cabochon fixing screws: 89mm
In stock
Can also fit on Caravelle and Floride S trumpets
In stock
4CV (Until 03/1955)
It is necessary to cut the connecting rods by 10mm depending on the assembly.
In stock
Solid washer in white zinc-plated brass for countersunk screws Ø 3mm and Ø 3.5mm
Ideal for fixing:
Headlining
Interior trim, carpets, rugs, etc.
Rubber mats
In stock
Retaining clips for brake caliper carrier, for use with a 54mm diameter caliper piston and a 20mm thick ventilated brake disc.
Clip length: 56mm
Clip width: 23.5mm
Sold as a set for one caliper (1 upper clip and 1...
In stock
Built-in short extensions
Straight coil terminal
Coil wire length: 50cm
This ignition harness consists of 4 spark plug wires and 1 coil wire.
We would like to point out that our spark plug wires are made with 7 mm...
In stock
Out of stock
In stock
In stock
In stock
Center distance of the cabochon fixing screws : 89mm
In stock
In stock
In stock
Valve guide sold individually
Inner diameter of the guide: Ø 7mm
Outer diameter of the guide: Ø 11.23mm
Height of the guide: 41.5mm
Material: Gray cast iron
Suitable for:
R12 / R15: Intake and exhaust
A110 V85:...
In stock
Please note this hose cannot replace the original oil hoses, use only to carry out an adaptable assembly using a connector and a new radiator.
Material: Black synthetic braid
Maximum operating pressure 35 bar and...
In stock
The oil filter sandwich plate fits between the oil filter and the engine block.
It offers improved oil flow thanks to wider, unrestricted internal channels, making it ideal for installing an additional oil cooler....
In stock
One pair of triangles is needed per side, so 2 pairs
In stock
Entered dimension of the collar: Ø 52mm
Diameter tube : Ø 32mm
In stock
In stock
Cooling Hose Compatible with Alpine:
A310.4 1600VE: From #1 to End of Series
A310.4 1600VF: From #1 to End of Series
A110 SC / Si (1600VD)
In stock
In stock
In stock
Installing this kit increases front axle rigidity and steering precision. It allows precise adjustment of front camber down to -2.5°.
Supplied with an adjustment wrench.
In stock
This headlight is designed to accept an original bulb holder secured with a quarter turn (with lugs)
Outer diameter of the lens (overall): Ø 150mm
Diameter of the lens inside the trim: Ø 145mm
Sold complete with...
In stock
Suitable for 1647 cc engines (Types 843-718 or 843-18 and 843-719 or 843-19)
Gasket dimensions:
Mounting hole spacing: 3 x 29.5 mm
Mounting hole diameter: Ø 8 mm
Inner diameter: Ø 12.5 mm
Réf OE Alpine / Renault :...
In stock
Out of stock
In stock
Overall length: 273cm
Sheath length: 245cm
Cable length: 271cm
Our cables are made in France and meet the assembly and quality standards of original equipment (OEM) cables from automotive manufacturers.
In stock
Suitable for WEBER 40DCOE, 45DCOE and IDF carburetors
Sold individually, requires 2 pieces per carburetor
Number 31 on the exploded view
Compatible with other WEBER carburetors, see below
In stock
Stainless steel airbox: high corrosion resistance and durability
In stock
In stock
Bearing Dimensions:
Dimension: Repair Dimension (+0.25)
Crankpin Diameter (A): Ø 43.73mm
Housing Diameter (B): Ø 47.62mm
Bearing Width (C): 17.75mm
Bearing Thickness (D): 1.92mm
Smooth, lug-type bearings with no...
In stock