Kit of 6 parts to be welded for conversion of rear cross member from 2 to 4 shock absorbers - R8G / A110

• This kit contains an M9 adjustment screw nut and an M8 nut.
• Kit sold with a strong Ø 38mm square gasket and a weak Ø 38mm gasket.
• The supply of these two seals allows you to install the most suitable seal depending on the wear of the caliper grooves.
• To identify a caliper with a square or round seal, refer to the symbol indicated on the caliper casting.
• A square symbol indicates a square seal, while a circle symbol indicates a round seal.
• It is essential to replace the same type of seal (round or square) according to the symbol on the caliper.
• We recommend checking the symbol displayed on each caliper, as a vehicle may have Calipers of different origins, some of which may have square joints and others round joints.
• It is not recommended to mix calipers on the same set, as this can lead to the risk of skewing during braking.

• Diameter of the 3 holes for the strike plate mounting screws: M8x100

These twin-tube hydraulic adjustable shock absorbers are designed for versatile use, such as sporty driving.

With an adjustable damping range from softest to firmest,they are perfect for performance driving, sporty riding, or competition, while also offering the comfort and safety needed for everyday use.

Features:

• Mounting eye width: 21mm
• Lower mounting eye inner diameter: Ø 9mm
• The internal adjustment allows you to modify the rebound damping of the shock absorber.
• Shock absorbers delivered at minimum spring rate (fully open, i.e., softest setting)
• Shock absorbers sold in pairs

Suitable for:

• R8G (R1134 / R1135): From 10/1964 to 1974
• Alpine A110: 1100cc / 1300cc / 1600cc (All models except A110 SC / SX and SI)
• Alpine GT4 (For rear crossmember with 4 shock absorbers)
• Florida S and Caravelle:From 06/1964 onwards... (For rear crossmember with 4 shock absorbers)

Detailed description of Koni shock absorbers,see below

• Carburetor mounting distance to the intake manifold: 110mm and 70mm
• Intake manifold height: 76mm
• Manifold supplied with O-rings (x4) and carburetor mounting studs (x8)

The carburetor mounts directly onto the manifold. Four O-rings ensure a tight seal; there's no need to use flexible or rigid flanges.