In stock
Best sellers
In stock
In stock
In stock
Intake manifold mounting distance: 70mm and 110mm
Carburetor mounting distance: 110mm and 70mm
Flange thickness: 19.3mm
Pipes diameter: Ø 40mm
Flanges supplied with O-rings (x4), paper gaskets (x4), and mounting...
In stock
In stock
In stock
This kit is suitable for original Bendix or remanufactured transmitters (AVP9114)
In stock
In stock
In stock
HTX COLLECTION 20W-50 is a customized solution for vintage and newer classic vehicles whose engines have been restored to their original condition, with or without turbochargers, particularly those manufactured since...
In stock
In stock
In stock
In stock
Need 1 AVP6816 gasket and 3 AVP6815 gaskets to equip an engine
In stock
In stock
Wiper shaft attachment: 5mm diameter shafts
Arm attachment to wiper blades by flat: 2.6x3.4mm
In stock
In stock
Overall length: 212.5 cm
- Sheath length: 166.5 cm
- Cable length: 202 cm
In stock
Joint dimensions: Ø 20x16x1mm
In stock
Designed to be mounted only with AVP springs: ref 4360, ref 4361 or ref 4362.
In stock
In stock
In stock
In stock
Suitable for: A310.4: 1600VE n°1066 at the end and 1600VF n°21066 at the end A310.6: All models (before and after 1980)
In stock
In stock
Stem length: 37mm
Membrane mounting hole spacing: 35mm
In stock
In stock
- Overall length: 138.5 cm
- Sheath length: 174 cm
- Cable length: 128cm
In stock
Gasket dimensions: Ø 20x12x1mm
Suitable for WEBER 40DCOE and 45DCOE carburetors
Number 2 and number 69 on exploded view
Sold individually, 1 piece required for one carburetor
Compatible with other WEBER carburetors,...
In stock
In stock
In stock
Please note that you also need the AVP9028 seal
In stock
In stock
Same as original Bosch Ref: 1 235 522 210
In stock
Ideal for prepared engines or to replace a mechanical fuel pump.
Flow rate: 125l/h
Max pressure: 0.30bar
Suction: -0.10bar
220° adjustable inlet and outlet tube: Ø 8mm
Self-regulated fuel pump
Dimensions: 73x126mm /...
In stock
In stock
In stock
In stock
In stock
In stock
This bracket attaches to the gearbox studs.
In stock
For mounting a belt width: 13mm
Groove for a 5mm key
A steel collar is installed on the oil seal surface for improved sealing and reduced pulley wear.
In stock
In stock
In stock
This ignition harness consists of 6 spark plug wires and 1 coil wire.
We would like to point out that our spark plug harnesses are made with 7mm diameter, black silicone wires with a standard copper core, which means...
In stock
Out of stock
Supplied with self-adhesive thermal protection to stick on the most suitable side depending on the assemblies.
In stock
In stock
In stock
In stock
In stock
Thickness: 1.2mm
In stock
Suitable for: A310.4: 1600VE n°1066 at the end and 1600VF n°21066 at the end A310.6: Before 1980 (n°1 to n°47708)
In stock
Sold individually
12V-55W H3 bulb supplied
In stock