Golden diamond monogram "Renault" front or rear bonnet - Ref 8558692

Bearing Dimensions:

• Dimension: Original (Standard) Dimension
• Crankpin Diameter (A): Ø 43.98mm
• Housing Diameter (B): Ø 47.62mm
• Bearing Width (C): 17.75mm
• Bearing Thickness (D): 1.80mm
• Smooth, lug-type bearings with no grease holes or grooves
• Bearing Material: Bimetal

• This kit contains an M9 adjustment screw nut and an M8 nut.
• Kit sold with a strong Ø 38mm square gasket and a weak Ø 38mm gasket.
• The supply of these two seals allows you to install the most suitable seal depending on the wear of the caliper grooves.
• To identify a caliper with a square or round seal, refer to the symbol indicated on the caliper casting.
• A square symbol indicates a square seal, while a circle symbol indicates a round seal.
• It is essential to replace the same type of seal (round or square) according to the symbol on the caliper.
• We recommend checking the symbol displayed on each caliper, as a vehicle may have Calipers of different origins, some of which may have square joints and others round joints.
• It is not recommended to mix calipers on the same set, as this can lead to the risk of skewing during braking.

The central unit is connected as follows:

• The 12V power supply (+ battery) wire on the "X" or "+" terminal
• The Switch or stalk control wire on the "L" or "Z" terminal
• The repeater indicator light wire (LED) on the "P" terminal

Suitable for 4 doors

Mounts with the stop switch reference 4423

This hose is also suitable for carburetors with a cold-start choke controlled by a thermostatic spring heated by hot water (Hose from the cold-start heater to the carburetor base)

• OE Renault Ref: 8575004 / 0857735000 / 7700502438

Suitable for:

• R8 (R1130 / R1132): Solex 32 DISTA / 32 DITA
• R8S (R1136): Weber 32DIR
• Caravelle / Floride S: Solex 32 DISTA / 32 DITA