Suitable for
Simca 1000: Drum brake
Simca 1000 Rallye / 1200S / CG (B1200): Disc brake
Length: 29cm - Male/Female fitting (Ø 3/8"-24UNF)
In stock
Simca 1000 Coupé Bertone braking
Our braking spare parts for the Simca 1000 Coupé Bertone
Discover here a wide range of parts to restore and ensure the proper functioning of the braking system of your Simca 1000 Coupé Bertone
Whether you are looking for wheel cylinders, hoses, master cylinder, brake disc, brake caliper kit, lockheed, reservoir, connector, stop switch, repair kit, copper braking circuit...at AVP, Arnaud Ventoux Parts, you will find everything you need to bring your old car back to life with quality components.
This kit contains an M9 adjustment screw nut and an M8 nut
To identify a caliper with a square or round joint, refer to the symbol indicated on the caliper casting.
A square symbol indicates a square joint, while a...
Out of stock
This kit contains an M9 adjustment screw nut and an M8 nut
To identify a caliper with a square or round seal, refer to the symbol indicated on the caliper casting.
A square symbol indicates a square seal, while a...
In stock
In stock
In stock
In stock
In stock
For a cable with a cable stop end: Ø 14mm
OE Renault Ref: 8704054 / 0870405400
In stock
In stock
In stock
In stock
Out of stock
In stock
In stock
In stock
Ideal for degreasing all your braking elements or other mechanical parts.
In stock
In stock
Delivery in France only
Does not absorb moisture, thus protecting brake systems from rust, which accumulates on wheel cylinders and destroys the brake pads after a few brake applications when the brakes are restarted...
In stock
Suitable for taps: M3 to M10
Short tap holder - Length 85 mm
Reversible ratchet: Left-hand, right-hand, and fixed ratchet
Two-jaw steel grip
In stock
UNF thread tap (2B tolerance): Ø 3/8"-24 UNF (Right-hand thread)
Tap length (Overall): 63 mm
Mounting drive: 5.5 mm square
Flat end tap, suitable for: Through and blind holes
Machine tap: Only one tap is needed to...
In stock
Suitable for die outer diameter: Ø 38.1mm
Die height: 12.7mm
Two-arm die holder made of high-quality steel
In stock
ISO standard metric die: M10x125 (Fine thread - Right-hand thread)
Die outer diameter: Ø 38.1 mm
Die height: 13.1 mm
Suitable for the following materials: Soft steel / Hard steel / Cast iron / Stainless steel /...
In stock
ISO standard metric die: M12x125 (Fine thread - Right-hand thread)
Die outer diameter: Ø 38.1 mm
Die height: 12.8 mm
Suitable for the following materials: Soft steel / Hard steel / Cast iron / Stainless steel /...
In stock
Suitable for die outer diameter: Ø 30mm
Die height: 10mm
Two-arm die holder made of high-quality steel
In stock
UNF die, DIN223 standard: Ø 3/8"-24 UNF (Right-hand thread)
Outer diameter of the die: Ø 30 mm
Die height: 11 mm
Suitable for the following materials: Soft steel / Hard steel / Cast iron / Stainless steel / Aluminum...
In stock