Rear brake pad set

Ideal for prepared engines or to replace a mechanical fuel pump.

• Flow rate: 130l/h
• Max pressure: 0.15bar
• Suction: -0.20bar
• 220° adjustable inlet and outlet tube: Ø 8mm
• Self-regulated fuel pump
• Dimensions: 73x126mm / Weight 820g

Ideal for vehicles with the engine in the rear position with a tank at the front, pump to be positioned in the compartment motor.

It is recommended to mount the pump horizontally, with the "Out" outlet at the top.

Pay attention to the connection polarity: red cable "+" / black cable "-"

• This kit contains an M9 adjustment screw nut and an M8 nut.
• Kit sold with a strong Ø 38mm square gasket and a weak Ø 38mm gasket.
• The supply of these two seals allows you to install the most suitable seal depending on the wear of the caliper grooves.
• To identify a caliper with a square or round seal, refer to the symbol indicated on the caliper casting.
• A square symbol indicates a square seal, while a circle symbol indicates a round seal.
• It is essential to replace the same type of seal (round or square) according to the symbol on the caliper.
• We recommend checking the symbol displayed on each caliper, as a vehicle may have Calipers of different origins, some of which may have square joints and others round joints.
• It is not recommended to mix calipers on the same set, as this can lead to the risk of skewing during braking.

• Fitting for flat wiper arm width 6mm

• Inlet / outlet connection: BSP 1/2" x14 (x2)
• Threaded sleeve: male Ø3/4" - 16UNF and female Ø3/4" - 16UNF

Please note, the oil filter plate does not correspond to the original hoses and fittings. Provide for the replacement of these fittings and hoses.

• Grease nipple with steel ball
• Grease nipple (overall) height: 15.20 mm
• Grease nipple with a 7 key recess

Suitable for:

• R8.G (1255cc and 1296cc Engine)
• A110 1100G and 1300G
• GT4 / Matradjet (1255cc Engine)
• R12.G / R17.G (1600cc Engine)
• Super 5GT Turbo and R11 Turbo: Cooler spark plug (1400cc Turbo Engine)