Tap Ø 3/8"-24UNF (Right-hand thread)

Brake Disc Specifications:

• Outer Diameter: Ø 260mm
• Inner Centering Diameter: Ø 60mm
• Mounting Hole Spacing: 71mm
• Disc Offset: 32mm
• Brake Disc Thickness: 8mm

• This kit contains an M9 adjustment screw nut and an M8 nut.
• Kit sold with a strong Ø 38mm square gasket and a weak Ø 38mm gasket.
• The supply of these two seals allows you to install the most suitable seal depending on the wear of the caliper grooves.
• To identify a caliper with a square or round seal, refer to the symbol indicated on the caliper casting.
• A square symbol indicates a square seal, while a circle symbol indicates a round seal.
• It is essential to replace the same type of seal (round or square) according to the symbol on the caliper.
• We recommend checking the symbol displayed on each caliper, as a vehicle may have Calipers of different origins, some of which may have square joints and others round joints.
• It is not recommended to mix calipers on the same set, as this can lead to the risk of skewing during braking.

4CV: Drum brake (From 06/1953 until end of series)

Alpine A106: Drum brake

Dauphine (All models): Disc brake

Caravelle / Florida: Disc brake

R10 / R8 (All models): Disc brake

Alpine A110 and GT4: Disc brake

Matradjet: Disc brake 

This kit contains x4 hoses Ø 3/8"-24UNF - Length of hoses 32cm and 26cm

To be adjusted on your vehicle for a perfect finish.

• Dimension of the headlight bubble: length 34cm and width 24.5cm

• UNF die, DIN223 standard: Ø 3/8"-24 UNF (Right-hand thread)
• Outer diameter of the die: Ø 30 mm
• Die height: 11 mm
• Suitable for the following materials: Soft steel / Hard steel / Cast iron / Stainless steel / Aluminum
• High-quality, high-speed steel (HSS) hand-cut slotted die