Best sellers
In stock
In stock
Inlet diameter: 61mm
Dimension of the fitting on the carburettor: Length 115mm x Length 70mm
Out of stock
In stock
Out of stock
Suitable for:
R8 / A110: Rear Big Brake Assembly
R5 Alpine Turbo (122B): Rear Brake
A310.4: Rear Brake
A310.6 (Pre-1980): Rear Brake
R12G / R17G: Rear Brake
For competition use only, do not use these pads on public...
In stock
R8G / A110 (1255 cc /1296 cc ) Centering pins to be removed
R5 Alpine (1223)
R5 Alpine Turbo (122B)
Out of stock
In stock
Clutch cable with chassis mounting
- Overall length: 206.5 cm
- Sheath length: 148 cm
- Cable length: 196cm
In stock
In stock
Lower fixing eye width 21mm
Lower fixing screw Ø 9mm
In stock
In stock
Out of stock
In stock
In stock
In stock
In stock
In stock
The lubrication hole must be drilled after installation in the block.
In stock
In stock
Out of stock
Compatible with :
- R8G R1134 (1108cc engine - Type 804) / R1135 (1255cc and 1296cc engine - Type 812)
- Alpine A110 1108cc / 1289cc (V85) / 1300G / 1300S
- R5 Turbo 1 and 2 (1397cc)
- R12.TS (1289cc)
In stock
In stock
Transforms rust into a stable, black layer
Indispensable for inaccessible corners of the bodywork
Apply pure and with a brush on all rusty surfaces
In stock
In stock
In stock
In stock
In stock
In stock
In stock
In stock
In stock
In stock
Harness for mounting with the coil on the left rear wing
Coil wire length: 63cm
Ignition wire length: 49cm / 53cm / 58cm / 62.5cm
In stock
Stem length: 38mm
Center distance of the membrane holes 27mm
In stock
Out of stock
For round end master cylinder rod.
For R12 L/TL (R1170) n°296081 at the end of the series
For R12 Break L/TL (R1330) n°41502 at the end of the series.
In stock
In stock
In stock
In stock
In stock
Overall length: 195cm
Sheath length: 138cmm
Cable length: 187cm
Suitable for cars with handbrake under the dashboard:
A110.1100 VA and VB
A110.1300 VA and VB (From No. 1 to 11951)
A110.1300 VC (From No. 1 to...
In stock
In stock
In stock
In stock
Out of stock
In stock
In stock
Key Length: 56mm
Key Width: 23.5mm
Suitable for:
R5 Alpine (Coupe and Group 2): Front Brakes
R12G / R17G: Front Brakes
A310.4: Front and Rear Brakes
A310 V6 Before 1980 (#1 to #47708): Front and Rear Brakes
In stock
Only delivery in France
Epoxy coating for the interior of the engine block.
0.5kg of resin and hardener
0.5l of thinner
In stock
Out of stock