Weber 40 DCOE or 45 DCOE carburettor needle - Ø 200

• Shifting washer against throttle shaft bearing for carburettor WEBER 40DCOE AND WEBER 45DCOE
• Thickness: 0.5mm
• Inner Ø: 7mm
• Outer Ø: 14mm
• Number 77 on exploded view

Ideal for prepared engines or to replace a mechanical fuel pump.

• Flow rate: 125l/h
• Max pressure: 0.30bar
• Suction: -0.10bar
• 220° adjustable inlet and outlet tube: Ø 8mm
• Self-regulated fuel pump
• Dimensions: 73x126mm / Weight: 820g

Ideal for vehicles with the engine in the rear position with a tank at the front, pump to be positioned close to the tank.

It It is recommended to mount the pump horizontally, with the "Out" outlet at the top.

Pay attention to the connection polarity: red cable "+" / black cable "-"

• This kit contains an M9 adjustment screw nut and an M8 nut.
• Kit sold with a strong Ø 38mm square gasket and a weak Ø 38mm gasket.
• The supply of these two seals allows you to install the most suitable seal depending on the wear of the caliper grooves.
• To identify a caliper with a square or round seal, refer to the symbol indicated on the caliper casting.
• A square symbol indicates a square seal, while a circle symbol indicates a round seal.
• It is essential to replace the same type of seal (round or square) according to the symbol on the caliper.
• We recommend checking the symbol displayed on each caliper, as a vehicle may have Calipers of different origins, some of which may have square joints and others round joints.
• It is not recommended to mix calipers on the same set, as this can lead to the risk of skewing during braking.