Split pin for securing the pump control on the throttle valve shaft for WEBER 40DCOE and 45DCOE carburetors
Number 82 on exploded view
Compatible with WEBER carburetors: 32 DCOF, 35 DCNL, 36 IDF, 38 DCNL, 38 DCOE, 40...
In stock
Best sellers
Axle for carburetor WEBER 40DCOE old generation
ATTENTION mounts with flat screw (Ref 48052)
Drilling for recovery pump control to be done
Length overall : 180mm
Number 85 on exploded view
In stock
Suitable for old generation WEBER 45DCOE carburettor
WARNING: must be mounted with flat screw (Ref 48052)
Drilling for accelerator pump control to be done.
Overall length: 180mm
Number 85 on exploded view
Also...
In stock
In stock
Banjo screw M12
Sold individually without gasket
In stock
The VARTA BLUE Dynamic battery range is ideal for vehicles with standard electrical equipment, with excellent cold-start performance.
This battery is intended for small vehicles or older models with lower power...
In stock
The 6V 140Ah 900A battery is specially designed for classic and vintage vehicles requiring a 6-volt power supply.
With an impressive 140 Ah capacity and a 900A starting power, this battery offers reliable...
In stock
In stock
Allows shock absorber hardness adjustment and ride height adjustment (40mm range).
In stock
In stock
Limited special offer
In stock
In stock
In stock
In stock
Out of stock
In stock
In stock
Out of stock
In stock
In stock
Heater hose compatible with Alpine A310.4 (1st Version):
A310.4 1600VE: From #1 to #1002
A310.4 1600VF: From #1 to #21002
In stock
Heater hose compatible with Alpine A310.4 (1st and 2nd Version):
A310.4 1600VE: From #1 to end of series
A310.4 1600VF: From #1 to end of series
In stock
Out of stock
In stock
Fixed with two threaded studs with M5 nuts
Fixing center distance: 90mm
Overall length: 120mm
In stock
Rigid "Bark Brown" colored fabric trim mounted on hardboard
Trims to glue or screw
Kit includes: Two center pillars and two rear wheel arches
Out of stock
Interior door trim in "Brown Bark" fabric and rigid storage compartment mounted on hardboard
Fabric trim to be glued to the bottom of the door with neoprene glue; no drilling is required.
Compatible with all 4CV...
In stock
Adaptable leather gear knob with visible stitching
Knob dimensions:
Knob diameter: Ø 47.5mm
Knob height: 60mm
Supplied with 3 different tips to fit all types of levers (screwed or glued):
Chrome screw-on tip:...
In stock
Dashboard-mounted gear knob for 4-speed gearbox and reverse
Knob entry diameter: 17.5mm
High-quality black plastic knob to stick onto the gear lever
Suitable for:
R4 / 4L: All models from 1974 onwards - With...
In stock
Bearing Dimensions (Sold in packs of 12):
Crankshaft Diameter: Ø 52.30mm
Bearing Diameter: Ø 56.0mm
Width: 17.65mm
Thickness: 1.84mm
Suitable for the following engines:
Alpine A310 V6: PRV 112.730 Engine
Alpine V6...
In stock
This ignition harness consists of 4 spark plug wires and one coil wire.
Terminals on coil straight
Length of coil cable: 61cm
Length of 2 spark plug cables: 26.5cm
Length of 2 spark plug cables: 36.5cm
We would like...
In stock
Built-in short extensions
Straight coil terminal
Coil wire length: 50cm
This ignition harness consists of 4 spark plug wires and one coil wire.
We would like to point out that our spark plug harnesses are...
In stock
In stock
Specific screw: M12x150 (Fine Pitch)
Length under head: 21mm
OE Renault Ref: 706317606 / 0706317606
In stock
To be installed with a straight grease nipple M6x100 (AVP C107)
Specific screw: M12x150 (Fine Pitch)
OE Renault Ref: 8546170 / 0854617000
In stock
Alpine OE Ref: 6000056888
In stock
In stock
Alpine OE Ref: 6000002996 / 6000048136
In stock
Neoprene-type contact adhesive in spray form, extra-strong. It adheres to many materials such as leather, fabrics, plastic, woodwork, etc. Allows simple, rapid, precise, and durable bonding of materials. Applies as a...
In stock
Black faux leather interior door panels mounted on hardboard for Alpine A110 with round handle (up to 1973)
Set of 4 trim pieces for both doors
Drilling provided to insert the original AVP 4974 fixing clips (Requires...
In stock
3-pin base
Dimensions: 45 x 82 mm
Due to the wide variety of bulb types used, please check compatibility with your vehicle.
In stock
The mounting points on the strut (screws) are offset.
Shock absorbers with original calibration give you the option to replace your shock absorbers with models that provide comfort and handling comparable to those...
In stock
Warning: This part number must only be installed for a luggage compartment measuring 660mm x 505mm
Must only be installed with part number AVP 699041 + AVP 699042 + AVP 699044 + AVP 699045
Warning: Please check the...
Out of stock
Dimensions:
Must be installed only with AVP ref 699041 + AVP 699043 + AVP 699044 + AVP 699045
Caution: Check the luggage compartment dimensions carefully
Out of stock
Out of stock
Out of stock
Recommended installation with BOSTIK glue Ref.,,,,,,,,,,,,,,,,,,
Out of stock
Out of stock
Out of stock
Out of stock
Out of stock
Out of stock
Black faux leather gear shift cover for Renault Alpine A110
Black faux leather sewn onto 12mm thick foam
Recommended installation with BOSTIK glue Ref,,,,,,,,,,,,,,,,,
Out of stock
Out of stock
Recommended installation with BOSTIK glue Ref.,,,,,,,,,,,,,,,,
Out of stock
Alpine A110 throttle cable cover
In original black imitation leather.
Out of stock
Pavillon Alpine A110 en simili cuir (1968-1972)
Le pavillon est coupé plus large pour avoir plus d'amplitude lors la mise en place.
Out of stock
Front left and right floor mats
Black with blue leather "A"
Premium quality, Made in France
In stock
Complete carpet and leatherette interior for Alpine A110 after 1968
Black color
Premium quality, made in France
Note: For body with a central beam (tunnel) clearance width of 100mm and a luggage/suitcase compartment...
Out of stock
Complete carpet and leatherette interior for Alpine A110 after 1968
Black color
Premium quality, made in France
Note: For body with a central beam (tunnel) clearance width of 100mm and a luggage/suitcase compartment...
Out of stock