ISO standard metric die: M10x125 (Fine thread - Right-hand thread)
Die outer diameter: Ø 38.1 mm
Die height: 13.1 mm
Suitable for the following materials: Soft steel / Hard steel / Cast iron / Stainless steel /...
In stock
Best sellers
Suitable for die outer diameter: Ø 38.1mm
Die height: 12.7mm
Two-arm die holder made of high-quality steel
In stock
UNF thread tap (2B tolerance): Ø 3/8"-24 UNF (Right-hand thread)
Tap length (Overall): 63 mm
Mounting drive: 5.5 mm square
Flat end tap, suitable for: Through and blind holes
Machine tap: Only one tap is needed to...
In stock
Mounts between the front muffler and the rear pipe. See photo #2
Renault OE Ref: 7702581798
Inlet Pipe Diameter: Ø 36mm (inner)
Outlet Pipe Diameter: Ø 32mm (inner)
Suitable for:
R4 (1108cc) from 1976 to 09/1979
R4...
In stock
Suitable for the following vehicles:
R5 / R18 / R21 / R25 / R30 / : Rear Brakes
R8: Big Rear Brakes
R5 Alpine Turbo (122B): Rear Brakes
R12G / R17G: Rear Brakes
A110: Big Rear Brakes
A310.4: Rear Brakes
Alpine A310...
In stock
Suitable for the following vehicles:
SUPER 5 / R9 / R11 / R19:Rear Brakes
Clio 1.8L 16V: Rear Brakes
Clio Williams-16V: Rear Brakes
Pad dimensions:
Width: 105mm
Height: 54.9mm
Thickness:...
In stock
Suitable for the following vehicles:
SUPER 5 / R9 / R11 / R18 / R19 / R21 / R25: Front Brakes
Clio 1.8L 16V / Clio Williams: Front Brakes
Alpine GTA V6 GT (D500) et V6 Turbo (D501 et D502) : Front Brakes
Brake...
In stock
Velcro fastening
Black imitation leather interior door panels mounted on reinforced panels for Alpine A110 with round handle (up to 1973)
Set of 4 trim pieces for both doors
Premium finish
In stock
Velcro fastening
Black leatherette interior door panels mounted on reinforced panels for Alpine A110 with round handle (up to 1973)
Set of 4 trim pieces for both doors
Premium finish
In stock
Black simili leather sewn onto 12mm thick foam
In stock
Black simili leather stitched onto 12mm thick foam
In stock
The mounting points on the strut (bolts) are offset.
Maxigaz Sport Driving shock absorbers replace the original oil-filled models with higher-performance gas technology, ideal for intensive use in sport driving,...
In stock
Suitable for the following vehicles:
R4 / 4L: Type R1120 - R1121 - R1122: up to chassis number 954000: from 1961 -> 09/1968
R4 / 4L: Type R1123 - R1124: up to chassis number 627131: from 1962 -> 06/1968
R4 Van:...
In stock
1-pin base / 3 aligned pins
Dimensions: 40x61mm
Due to the multitude of bulb types used, please check compatibility with your vehicle
In stock
2-pin base / 3 aligned pins
Dimensions: 40x61mm
Due to the multitude of bulb types used, please check compatibility with your vehicle
In stock
Mounts between the exhaust manifold outlet pipe and the intermediate muffler.
Renault OE Ref: 7700513569 / 1108173001
Inlet Pipe Diameter: Ø 50mm (inner)
Outlet Pipe Diameter: Ø 45mm (outer)
Suitable for:
R16 TS...
In stock
Mounts between the intermediate pipe and the exhaust outlet pipe
Renault OE Ref: 0821684600 / 7700562545
Inlet Pipe Diameter: Ø 40mm (inner)
Outlet Pipe Diameter: Ø 35mm (outer)
Suitable for:
R16 L (R1150) from...
In stock
Suitable for:
Clio Williams (Up to 02/1994): Rear Windscreen Wiper
In stock
Mounting distance: 11.5 cm
Overall length: 13 cm
Height: 3.5 cm
In stock
Rigid "Grey" leatherette trim mounted on hardboard
Trims to glue or screw
Kit includes: Two center pillars and two rear wheel arches
In stock
Rigid "Bark Brown" colored fabric trim mounted on hardboard
Trims to glue or screw
Kit includes: Two center pillars and two rear wheel arches
In stock
Seat cover in blue leatherette and plaid fabric (Blue / Green and red)
Red piping on the edge of the seats.
Kit contents:
Front seat cover: Seat, backrest and headrest
Rear seat cover: Seat and backrest
In stock
Kit of 4 interior door panels in gray imitation leather and fabric in "Red Scottish" color - R4 / 4L
Inner door panels in gray leatherette with plaid (red/blue and gray) mounted on hardboard
Set of 4 trim pieces for the two front doors and two rear doors
Drilled to insert the original mounting clips. (Requires 56...
Out of stock
Bearing Dimensions (Sold x12):
Crankshaft Diameter: Ø 59.99mm
Bearing Housing Diameter: Ø 63.72mm
Width: 17.72mm
Thickness: 1.84mm
Suitable for the following engines:
Alpine GTA V6 Turbo (D501 and D502) and Renault...
In stock
Dimensions: 11X41mm
Part Number: 7701348083
Due to the many different bulb types used, please check compatibility with your vehicle.
In stock
The mounting points on the strut (bolts) are aligned.
Oil-filled shock absorbers with original equipment specifications allow you to replace your shock absorbers with models that provide comfort and handling...
In stock
Warning: This part number must only be installed for a luggage compartment measuring 660mm x 505mm
Must only be installed with part number AVP 699041 + AVP 699042 + AVP 699044 + AVP 699045
Warning: Please check the...
In stock
Dimensions:
Must be installed only with AVP ref 699041 + AVP 699043 + AVP 699044 + AVP 699045
Caution: Check the luggage compartment dimensions carefully
In stock
Recommended installation with BOSTIK glue Ref.,,,,,,,,,,,,,,,,,,
In stock
In stock
Black faux leather sewn onto 12mm thick foam
In stock
Black faux leather sewn onto 12mm thick foam
In stock
Black quilted trim, left side, for Renault Alpine A110
Black faux leather sewn onto 12mm thick foam
Recommended installation with BOSTIK glue Ref,,,,,,,,,,,,,,,
In stock
Alpine A110 Headliner in Faux Leather (1972-1977)
The headliner is cut wider to provide more room for installation.
Out of stock
The dashboard includes locations for the following components (from left to right):
Windshield washer pump
Left air vent
Windshield wiper switch
High beam headlight switch
Fuel level indicator
Tachometer
Speedometer...
In stock
Oil-filled shock absorbers with standard calibration (Super Comfort range)
Supplied with silentblocs, mounting washers, and spring retainers
Height under spring retainer (See dimension H): 177mm
Suitable for:
R12...
In stock
Lift Features:
Double-acting gas lift
Mounting center distance: 610mm
Lift stroke: 250mm
Mounting eye diameter: Ø 8mm (x2)
Cylinder force: 300N
Only suitable for models with 2 cylinders, for single cylinders, use...
In stock
Suitable for:
Florida S (1962-1967): Engine 689-01 and 689-02 (1962-1967)
Caravelle (1962-1967): Engine 689-01 and 689-02 (1962-1967)
R8 (1962-1967): Engine 689-01 and 689-02
Sets are supplied with the following:...
In stock
Steering wheel covered in high-quality black leather with white stitching and parallel patterns
Steering wheel entirely handmade
Steering wheel outer diameter: Ø 350mm
Dotting: 39mm
Steering wheel cross-section:...
In stock
Suitable for WEBER 40DCOE and 45DCOE carburetors
Number 83 on exploded view
In stock
Suitable for older generation WEBER 45DCOE carburetors (the bearing surfaces differ from the shafts of modern versions)
Caution: The throttle plates or flaps must be mounted using flat-head screws. (AVP48052)
The...
In stock
This kit is made up of the following copper pipes:
- from the brake master cylinder to the pressure drop indicator (1/2"-20UNF connection)
- from the brake master cylinder to the pressure drop indicator (3/8"-24UNF...
In stock
In stock
In stock
In stock
These twin-tube hydraulic adjustable shock absorbers are designed for versatile use, such as sporty driving.
With an adjustable damping range from softest to firmest,they are perfect for performance driving, sporty...
In stock
In stock
Segment Characteristics:
Segment Diameter:Ø 60mm
Thickness of Upper Segments (Fire-resistant): 1.50mm
Thickness of Intermediate Segments (Waterproof): 1.50mm
Low ring thickness (Scraper): 3.5mm
It is essential...
In stock
Front fender repair panel.
It is recommended to perform a test fit on all body panels to check their alignment.
Some adjustments may be necessary.
In stock
Out of stock
Out of stock
In stock
Metallic sandblasting and epoxy paint finish
In stock
Heater hose compatible with Alpine A310.4 (1st and 2nd Version):
A310.4 1600VE: From #1 to end of series
A310.4 1600VF: From #1 to end of series
In stock
Heater hose compatible with Alpine A310.4 (1st Version):
A310.4 1600VE: From #1 to #1002
A310.4 1600VF: From #1 to #21002
In stock
Out of stock
Out of stock
In stock
FACET Silver Top 113 l/h Fuel Pump (476087) self-regulating with integrated fuel filter
These pumps reduce the "Vapor Lock" effect by allowing for a more consistent fuel supply.
They must be mounted in a vertical...
In stock
FACET Silver Top 113 l/h Fuel Pump (476087) self-regulating with integrated fuel filter
These pumps reduce the "Vapor Lock" effect by allowing for a more consistent fuel supply.
They must be mounted in a vertical...
In stock
Bearing Dimensions:
Size: Original (Standard) Size
Crankshaft Diameter (A): Ø 43.98mm
Case Diameter (B): Ø 47.62mm
Bearing Width (C): 17.75mm
Bearing Thickness (D): 1.80mm
Smooth bearings with tabs and lubrication...
In stock
Kit consisting of three door lock cylinders and two identical keys
Total cylinder length: 36mm
Length from head to fixing pin: 30mm
Cylinder head diameter: Ø 15.20mm
Lock cylinder diameter: Ø 11.50mm
Renault OE Ref:...
In stock
Kit consisting of two door lock cylinders and two identical keys
Total cylinder length: 36mm
Length from head to fixing pin: 30mm
Cylinder head diameter: Ø 15.20mm
Lock cylinder diameter: Ø 11.50mm
Renault OE part...
Out of stock
Water temperature sensor for Simca 1000 (1st Version) with engine temperature warning light on the dashboard (From early models to 1974)
Sensor diameter: M16 - 1.50 pitch (Tapered)
Connector: Spade terminal, 6.3mm...
In stock
Electric and mechanical brake light switch
Mounting diameter: M12 - 1.25 pitch
Connector: 6.3mm wide spade terminal (x2)
Sold with a locking nut
Suitable for:
Simca 1000 Rallye
Simca Rallye 1
Simca 1200S
Simca...
In stock
The rigid sintered disc is equipped with sintered metal pads and has no damping springs. It can handle higher engine torque and offers more direct gear changes.
Mounts in place of the original disc.
Compatible with...
In stock
Suitable for Estafette vans with Type 688 (1108cc) and Type 810 (1289cc) engines
Renault OE Ref: 0555485200 / 7704000281
In stock
Supplied complete with 12V / 21W (BA15s)
Fixing hole spacing: 34mm
Dimensions: Length 12cm x Height 6cm x Depth 5.5cm
Out of stock
Supplied without bulb holder and without bulb
Seima type mounting
Side: Driver's side
Color: Transparent
In stock