Suitable for gearboxes:
- Gearbox 314 / 318 / 325 / 328
- Gearbox 330 / 334 / 354
- Renault OE Ref:5552361 / 0555236100
In stock
Kit of 6 screws and 6 washers for fixing the ice clutch mechanism for graphite thrust bearing
Reference:
1055
- Screws CHC M6 (Class 12.9) x6pcs
- Slotted crowel washer Ø 6mm x6pcs
€4.50
(tax incl.)
You may also like
- Special Premium Quality graphite for clutch release bearings
- Important: The release bearing clamping screw must be placed on the side opposite the fork
- It is possible to keep the release bearing and replace only the graphite ring if worn.
- Depending on the diameter of the return spring, it may be necessary to re-drill the release bearing mounting.
- It is recommended to soak the release bearing in warm engine oil and then wipe it dry before installation to avoid squeaking noises
Out of stock
Out of stock
In stock
Customers who bought this product also bought:
In stock
Cylinder head gasket specifications:
-
- Crimping diameter: Ø 59.7mm
- Cylinder head gasket thickness:1.40mm
Installation direction:
The marking "Top" or "Haut" on the cylinder head gasket must be facing the Cylinder head (upwards).
For gaskets that do not have "top" or "high" markings, but have a manufacturer's part number, orient this part number towards the cylinder head.
If there are no markings (TOP, HIGH, or manufacturer's part number), the gasket does not have a specific orientation.
However, it is still necessary to check the correct positioning of the water and oil passages to ensure proper installation.
In stock
- Useful length (L on photo diagram number 3): 12.5mm
- Sold with the pin
- OE Renault / Alpine Ref: 0705339100
In stock
-
- Angled hose outlet: Ø 3/8" - 24UNF (Ø 9.52mm)
Suitable for:
-
- 4CV: Right Rear Brake (From early 1956 to the end)
- Dauphine / Floride: Right Rear Brake
- Alpine A106 / A108: Right Rear Brake
In stock
In stock
- For mounting a belt width: 13mm
- Groove for a 5mm key
A steel collar is installed on the oil seal surface for improved sealing and reduced pulley wear.
In stock
These mounts improve the reliability and stability of the gearbox, whether for daily driving or competitive use.
These mounts are direct replacements for the original ones; no modifications are required.
Installation advice:
- When installing the side mounts, ensure the two metal plates of the mount are perfectly parallel to each other to prevent premature wear or tearing of the mount.
- Depending on the gearbox and mounting bracket models, spacing with one or two thick washers (+/- 2 mm per washer) may be necessary between the mount and the gearbox at the mounting studs. On other models, no spacing is required; installation can be performed without applying stress to the assembly.
Out of stock