In stock
Aluminum crankshaft pulley Ø108mm
Reference:
1064
- For mounting a belt width: 13mm
- Groove for a 5mm key
A steel collar is installed on the oil seal surface for improved sealing and reduced pulley wear.
€46.00
(tax incl.)
Order before 1pm and enjoy same day shipping !
Customers who bought this product also bought:
Cylinder head gasket specifications:
-
- Crimping diameter: Ø 59.7mm
- Cylinder head gasket thickness:1.40mm
Installation direction:
The marking "Top" or "Haut" on the cylinder head gasket must be facing the Cylinder head (upwards).
For gaskets that do not have "top" or "high" markings, but have a manufacturer's part number, orient this part number towards the cylinder head.
If there are no markings (TOP, HIGH, or manufacturer's part number), the gasket does not have a specific orientation.
However, it is still necessary to check the correct positioning of the water and oil passages to ensure proper installation.
In stock
- Original type screw with slotted recess
In stock
- The installation of the rear tie rods reduces the movement of the rear axle, providing the vehicle with improved road holding on the rear axle.
- The tie rods can be installed on a 4CV with the battery in the front trunk or the battery in the rear (after 1954). For the rear position, some modifications will be necessary.
- Installation instructions included.
In stock
- Special Premium Quality graphite for clutch release bearings
- Important: The release bearing clamping screw must be placed on the side opposite the fork
- It is possible to keep the release bearing and replace only the graphite ring if worn.
- Depending on the diameter of the return spring, it may be necessary to re-drill the release bearing mounting.
- It is recommended to soak the release bearing in warm engine oil and then wipe it dry before installation to avoid squeaking noises
Out of stock