Kit of 4 gearbox output felt seals (dust cover)

• This kit contains an M9 adjustment screw nut and an M8 nut.
• Kit sold with a strong Ø 38mm square gasket and a weak Ø 38mm gasket.
• The supply of these two seals allows you to install the most suitable seal depending on the wear of the caliper grooves.
• To identify a caliper with a square or round seal, refer to the symbol indicated on the caliper casting.
• A square symbol indicates a square seal, while a circle symbol indicates a round seal.
• It is essential to replace the same type of seal (round or square) according to the symbol on the caliper.
• We recommend checking the symbol displayed on each caliper, as a vehicle may have Calipers of different origins, some of which may have square joints and others round joints.
• It is not recommended to mix calipers on the same set, as this can lead to the risk of skewing during braking.

Suitable for:

• R8 / R8G / A110 : Front or rear disc (Big brake assembly)
• A110 1600 SX (VH) : Front or rear disc 
• R16 (L / TL / TS) / R16TX : Front disc
• A310.4 (No. 910 at the end of the series): Front disc
• A310 V6 - Before 1980 (No. 1 to No. 47708 ): Rear disc

Réf OE Renault : 0428906000 / 7700572631

• In some configurations, Weber DCOE carburetors are positioned directly above the exhaust, which can create vapor lock problems due to heat: our AVP48010 plate can solve this problem
• Plate can be covered with thermal protection
• In some cases, it is possible to have to cut the sheet metal slightly to allow the throttle control to function correctly over its entire range

• Fitting for flat wiper arm width 6mm