- Kit includes: 4 screws, 8 washers, and 4 nuts
- This kit allows you to install an aluminum shim on the pivot (right or left),
- 2 kits required per vehicle.
In stock
Aluminum shim for fixing the front brake caliper yokes (for large brake type assembly) - R8 / A110 - Ref 6000001386
Reference:
4443
- Shim sold individually, 2 shims required to equip a front axle.
- In addition to the aluminum shim for attaching the front caliper, a caliper yoke is required (not available in the AVP catalog)
- WARNING: This assembly is specific. We remind you that some brake caliper yokes may not be compatible with the so-called "Big Brake" assembly.
€80.00
(tax incl.)
Order before 1pm and enjoy same day shipping !
You may also like
- Washer sold individually
- One washer allows the centering of a brake disc on the pivot
- 2 washers are required to equip a front or rear axle.
In stock
Suitable for:
- R8 / R8G / A110 : Front or rear disc (Big brake assembly)
- A110 1600 SX (VH) : Front or rear disc
- R16 (L / TL / TS) / R16TX : Front disc
- A310.4 (No. 910 at the end of the series): Front disc
- A310 V6 - Before 1980 (No. 1 to No. 47708 ): Rear disc
Réf OE Renault : 0428906000 / 7700572631
In stock
Customers who bought this product also bought:
 - R8 / A110 - Ref 6000001386&media=https://www.arnaudventouxpieces.com/9490-large_default/set-of-two-heavy-brake-aluminum-shims-with-2-centering-rings.jpg){kind=link}
- Automatic spring-loaded tensioner
- Features a grease fitting to ensure lubrication and maintain tension of the chain guide against the chain
We prioritize quality and reliability: tensioner meets original equipment quality standards.
In stock
In stock
It is mandatory to change the calipers in pairs (Right and left caliper)
In stock
In stock
In stock
- The fork is suitable for "original ball thrust bearing" type mounting or for conversion with a guided thrust bearing.
- Mounting instructions provided.
It may be necessary to modify the fork by adding a diameter tube to the fork boss to move the fork/stop assembly forward.
In stock
-
- ATTENTION: straight, non-offset bracket for mounting a Bendix-type "big brake" caliper bracket
- Brake bracket mounting hole spacing: 100mm
- Original Alpine part number: 6000001437
- Fixing with AVP4300 screws
- ATTENTION, suitable for:
-Big brake setup identical to the original: 10mm thick rear brake disc (12mm - 2mm on the inner face) + Bendix R16 bracket with 100mm mounting hole spacing + original single-row wheel bearing + original hub
or
-Big brake setup with: Big bearing kit REF AVP6413 + 12mm rear brake disc REF AVP4444 + Bendix R16 bracket with 100mm mounting hole spacing
It is essential, in all cases, to check the centering of the brake disc in the Bendix bracket.
In stock