Set of 12 segments Ø70mm - Thickness 2Cx2x3.5mm

• Special Premium Quality graphite for clutch release bearings
• Important: The release bearing clamping screw must be placed on the side opposite the fork
• It is possible to keep the release bearing and replace only the graphite ring if worn.
• Depending on the diameter of the return spring, it may be necessary to re-drill the release bearing mounting.
• It is recommended to soak the release bearing in warm engine oil and then wipe it dry before installation to avoid squeaking noises

Bearing Dimensions:

• Dimension: Repair Dimension (+0.25)
• Junnel Diameter (A): Ø 45.75mm
• Housing Diameter (B): Ø 49.89mm
• Bearing Width (C): 24.50mm (x4)
• Bearing Width (C): 19.50mm (x6)
• Bearing Thickness (D): 2.04mm
• Smooth bearings with lugs and holes Lubrication (x5) and grooves (x5)
• Bearing material: Bi-metal

• The fork is suitable for "original ball thrust bearing" type mounting or for conversion with a guided thrust bearing.
• Mounting instructions provided.

It may be necessary to modify the fork by adding a diameter tube to the fork boss to move the fork/stop assembly forward.

Suitable for:

• Simca 1000 / 1200S / R1 / R2 / R3 / CG - Ref 22089M
• Renault R8 / R8G / Floride / Caravelle
• Alpine GT4 / A110 (1100Cm³ / 1300cm³)
• Matradjet

These bearings are only suitable for old generation water pumps for Renault and Alpine models, with a need for two bearings per water pump.