Hydraulic timing chain tensioner with automatic winding (Superior Quality)

• Exhaust valve without shoulder on the keying side to limit smoke caused by oil rising.
• Valve with low keyway

• Screw diameter: M8x100
• Overall length: 28.35mm
• Threaded length: 19mm
• Supplied with locking nut

Suitable for:

• Eye end cap of rack and pinion - Ref 0824373600 / 7700504987
• Front tie rod end cap or rear tie rod end cap - A110 - Ref 7700504987
• Exhaust hanger - A310 V6 - Ref 7700504987

Inner diameter of the eye: Ø 10mm

The sets are supplied with the following components:

• Liners (x4)
• Pistons (x4)
• Rings (x12)
• Pin (x4)

Dimensions of the different parts:

• • Liner bore diameter: Ø 73mm
  • Liner flange or top diameter (D): Ø 87.78mm
  • Liner base diameter (A): Ø 78.41mm
  • Overall height including skirts of cylinder liners (C):134mm
  • Height from top of cylinder liner to base seal area (E):94.87mm
  • Shaft dimensions:Ø 20x62mm (Cirlip-free mounting)
  • Ring thickness:1.75mm / 2mm / 4mm (Fireproof/Sealing/Scraper)
  • Base seal type:Paper gasket

Piston mounting direction: an arrow drawn perpendicular to the axis The piston ring gap is located on the top of the piston. It must be oriented in the direction of engine rotation during the connecting rod's downward stroke (see manufacturer's instructions or diagram).

It is essential to check the ring end gap of each piston ring before installing them on the pistons, according to the values ​​given by the manufacturer or in the supplied instructions.

During installation, the ring end gap must be evenly distributed around the piston circumference at 120° intervals.