Pump suction and discharge valve - Carburetor WEBER 40DCOE and 45DCOE

• This kit contains an M9 adjustment screw nut and an M8 nut.
• Kit sold with a strong Ø 38mm square gasket and a weak Ø 38mm gasket.
• The supply of these two seals allows you to install the most suitable seal depending on the wear of the caliper grooves.
• To identify a caliper with a square or round seal, refer to the symbol indicated on the caliper casting.
• A square symbol indicates a square seal, while a circle symbol indicates a round seal.
• It is essential to replace the same type of seal (round or square) according to the symbol on the caliper.
• We recommend checking the symbol displayed on each caliper, as a vehicle may have Calipers of different origins, some of which may have square joints and others round joints.
• It is not recommended to mix calipers on the same set, as this can lead to the risk of skewing during braking.

• Gasket dimensions: Ø 20x12x1mm
• Suitable for WEBER 40DCOE and 45DCOE carburetors
• Number 2 and number 69 on exploded view
• Sold individually, 1 piece required for one carburetor
• Compatible with other WEBER carburetors, see below

Suitable for:

• 4CV: Drum brake (From 06/1953 until the end of production)
• Alpine A106: Drum brake
• Dauphine (All models): Disc brake
• Caravelle / Floride: Disc brake
• R10 / R8 (All models): Disc brake
• R12G and R17 Gordini: Disc brake
• Alpine A110 and GT4: Disc brake

Suitable for:

• 4CV: Drum brake (From 06/1953 until end of series)
• Alpine A106: Drum brake
• Dauphine (All models): Disc brake
• Caravelle / Floride: Disc brake
• R10 / R8 (All models): Disc brake
• Alpine A110 and GT4: Disc brake
• Matradjet: Disc brake