Front right brake caliper Ø 48mm for mounting "Big brakes" (Bendix mounting)

• Sold with 3 fixing screws and the oil seal (Ø 17x30x7mm)
• Guide to be mounted when replacing a clutch with a graphite thrust bearing with a modern diaphragm clutch
• It is necessary to drill and tap in the clutch bell to mount the adaptation guide.
• Mounting instructions supplied with the kit

• Shim sold individually, 2 shims required to equip a front axle.
• In addition to the aluminum shim for attaching the front caliper, a caliper yoke is required (not available in the AVP catalog)
• WARNING: This assembly is specific. We remind you that some brake caliper yokes may not be compatible with the so-called "Big Brake" assembly.

Suitable for A110 / R8G / R16

• Key length: 51mm
• Key width: 23.5mm

• Distance between two pulley mounting screws: 37mm
• Pulley mounting using 3 x M8 screws (Not supplied)
• The heater outlets can be plugged using two 16mm diameter rubber plugs and one 10mm diameter plug
• Water pump sold with water pump gasket, plate gasket, and plate

Suitable for:

• • R8 / A110: Front Big Brakes
  • R5 Alpine Atmo (1223) and Alpine Turbo (122B): Front Brakes
  • A310.4: Front Brakes
  • A310 V6 (Pre-1980): Front Brakes
  • R12 (All models): Front Brakes
  • R15 / R16 / R17 (All models): Front Brakes

Brake pads with a retaining stop (B in the diagram) must be fitted with this stop facing forward (in the direction of wheel rotation).

For competition use only. Do not use these brake pads on the track. public.