Exhaust manifold gasket sheet (High temperature 350°C) to be cut - Thickness: 1.2mm

Reference:

C099

Sheet Dimensions: Length 50cm x Width 33cm
Sheet Thickness: 1.2mm
Ideal for making cylinder head gaskets for air-cooled engines, gaskets, and exhaust flanges. Temperature limit: 350°C.
Material consisting of two sheets of exfoliated graphite, stapled on either side of a perforated zinc-plated steel sheet.

You may also like

Sheet Dimensions: Length 50cm x Width 33cm
Sheet Thickness: 1.2mm
Ideal for making cylinder head gaskets and exhaust gaskets. A solution for severe thermal stresses. Temperature limit: 600°C, up to 1000°C in the combustion chamber.
Material consisting of two sheets of exfoliated graphite, stapled on either side of a perforated galvanized steel sheet.

Reference: C100

€84.00 (tax incl.)

In stock

Heat-resistant, ready-to-use sealing paste
To be applied before mounting the exhaust pipe at the assembly point. Does not seize, facilitates disassembly
Tube of paste: 150gr
PLEASE NOTE: This product can only be delivered to France.

Reference: C088

€11.00 (tax incl.)

In stock

Customers who bought this product also bought:

Screw dimensions:

Reference: 4319

€4.50 (tax incl.)

In stock

Reference: 4070

€10.00 (tax incl.)

Out of stock

Suitable for:

- 4CV: Left Rear Brake (From early 1956 to the end of production)
- Dauphine / Floride: Left Rear Brake
- Alpine A106 / A108: Left Rear Brake

Reference: 1418

€29.00 (tax incl.)

In stock

Reference: 4976

€12.00 (tax incl.)

In stock

Special Premium Quality graphite for clutch release bearings
Important: The release bearing clamping screw must be placed on the side opposite the fork
It is possible to keep the release bearing and replace only the graphite ring if worn.
Depending on the diameter of the return spring, it may be necessary to re-drill the release bearing mounting.
It is recommended to soak the release bearing in warm engine oil and then wipe it dry before installation to avoid squeaking noises