Sheet metal fuel tank - Caravelle (Convertible and Hard Top - Type R1133)

• This kit contains an M9 adjustment screw nut and an M8 nut.
• Kit sold with a strong Ø 38mm square gasket and a weak Ø 38mm gasket.
• The supply of these two seals allows you to install the most suitable seal depending on the wear of the caliper grooves.
• To identify a caliper with a square or round seal, refer to the symbol indicated on the caliper casting.
• A square symbol indicates a square seal, while a circle symbol indicates a round seal.
• It is essential to replace the same type of seal (round or square) according to the symbol on the caliper.
• We recommend checking the symbol displayed on each caliper, as a vehicle may have Calipers of different origins, some of which may have square joints and others round joints.
• It is not recommended to mix calipers on the same set, as this can lead to the risk of skewing during braking.

The thermal spacer insulates the carburetor from engine heat, thereby limiting "vapor lock" issues.

Spacer specifications:

• Mounting hole spacing: 59mm
• Mounting hole diameter: Ø 8.4mm
• Inner diameter: Ø 32mm
• Thickness: 5mm
• Material: Bakelite
• Sold individually

Suitable for:

• Eye end cap of rack and pinion - Ref 0824373600 / 7700504987
• Front tie rod end cap or rear tie rod end cap - A110 - Ref 7700504987
• Exhaust hanger - A310 V6 - Ref 7700504987

Inner diameter of the eye: Ø 10mm

• Special Premium Quality graphite for clutch release bearings
• Important: The release bearing clamping screw must be placed on the side opposite the fork
• It is possible to keep the release bearing and replace only the graphite ring if worn.
• Depending on the diameter of the return spring, it may be necessary to re-drill the release bearing mounting.
• It is recommended to soak the release bearing in warm engine oil and then wipe it dry before installation to avoid squeaking noises