Set of adjustable steering rods (For cone Ø 11mm to 12 mm)

• Longueur hors tout : 232cm
• Longueur de la gaine : 192cm 
• Longueur du câble : 221,5cm

Nos câbles sont de fabrication française et répondent aux normes d’assemblage et de qualité des câbles de première monte (origine) des constructeurs automobiles.

• Slanted hose outlet: Ø 3/8" - 24UNF (Ø 9.52mm)

• This kit contains an M9 adjustment screw nut and an M8 nut.
• Kit sold with a strong Ø 38mm square gasket and a weak Ø 38mm gasket.
• The supply of these two seals allows you to install the most suitable seal depending on the wear of the caliper grooves.
• To identify a caliper with a square or round seal, refer to the symbol indicated on the caliper casting.
• A square symbol indicates a square seal, while a circle symbol indicates a round seal.
• It is essential to replace the same type of seal (round or square) according to the symbol on the caliper.
• We recommend checking the symbol displayed on each caliper, as a vehicle may have Calipers of different origins, some of which may have square joints and others round joints.
• It is not recommended to mix calipers on the same set, as this can lead to the risk of skewing during braking.

Inlet and outlet Ø 6-8mm

• This kit contains an M9 adjustment screw nut and an M8 nut
• To identify a caliper with a square or round joint, refer to the symbol indicated on the caliper casting.
• A square symbol indicates a square joint, while a circle symbol indicates a round joint.
• It is essential to preserve and replace the joint that originally came with the caliper.
• We recommend checking the symbol displayed on each caliper, as a vehicle may have calipers from different origins, some with square joints and others with round joints.
• It is not recommended to mix calipers on the same axle, as this can lead to the risk of them slipping during braking.

• The kit contains the following studs: M6x25 x3pcs (Ref 1016060256) + M6x30 x2pcs (Ref 1016060306) + M6x45 x1pcs (Ref 7059146)
• Only for water pumps with 7 mounting holes