×

Set of 8 rubber silentblocks between carb and INTAKE pipe

Reference:
4852
€28.00 (tax incl.)
Order before 1pm and enjoy same day shipping !
In stock
Product Details
4852
Customers who bought this product also bought:
  • Points set with internal adjusting screw, suitable for distributors with and without vacuum advance
  • Brand: Ducellier
  • Renault OE Ref: 0854137800 / 608012 / 618701 / 71133 (Ducellier)
Reference: 4707
€6.00 (tax incl.)
Add to cart
In stock

Exhaust heat wrap reduces heat radiation from manifolds, silencers, or full exhaust systems when wrapped directly around the pipes. It effectively protects the engine bay and heat-sensitive components (starter motor, alternator, etc.).

High-quality fiberglass insulation wrap, distinguished by its high heat resistance—withstanding temperatures up to 550°C.

  • Wrap width: 50mm
  • Roll length: 5 linear meters
  • Color: Beige
  • Water-repellent, heat- and cold-resistant wrap; offers good chemical resistance and is harmless to health.
Reference: 40129
€26.00 (tax incl.)
Add to cart
In stock

Kit specifications (Tie rods / Ball joints and boots):

  • Ball joint taper diameter (Steering knuckle side): Top of taper Ø 11mm / Bottom of taper Ø 12mm
  • Ball joint taper stud thread diameter: M10 x 1.25 (right-hand thread)
  • Ball joint stud thread diameter (into tie rod): M14 x 1.50 (right-hand thread)
  • Tie rod thread diameter (into steering rack): M12 x 1.00 (right-hand thread)
  • Minimum length of tie rod/ball joint assembly: 26 cm (measured from the contact point against the steering rack to the center of the ball joint stud on the steering knuckle side)
  • Maximum adjustment of the tie rod/ball joint assembly: 29 cm (measured from the contact point against the steering rack to the center of the ball joint at the steering knuckle end)
  • Includes: 2 steering rack boots, 2 steering ball joints (with nuts and locknuts), and 2 steering tie rods.

Suitable for:

  • R8 (All models)
  • Caravelle / Floride S
  • A110 (All models) / Alpine GT4
  • Matradjet

This adjustable steering kit replaces the original "fork-type" steering tie rods.

To install the adjustable tie rods, you must remove the steering rack eyelet bushing and replace the steering rack boots with the specific AVP4620 boots (included in the kit).

Reference: 4601
€99.00 (tax incl.)
View more
Out of stock
1