Kit of 4 "Goodridge" aviation brake hoses - R5 Alpine (1223) - Front disc brake and rear drum brake

The sets are supplied with the following components:

• Liners (x4)
• Pistons (x4)
• Rings (x12)
• Pin (x4)

Dimensions of the various parts:

• • Liner bore diameter: Ø 76mm
  • Liner flange or top diameter (D): Ø 90.10mm
  • Liner base diameter (A): Ø 80.60mm
  • Overall height including skirts of cylinder liners (C): 134mm
  • Height from top of cylinder liner to base seal area (E): 95mm
  • Shaft dimensions: Ø 20x65mm (Cirlip-free mounting)
  • Ring thickness: 1.75mm / 2mm / 4mm (Fireproof/Sealing/Scraper)
  • Base seal type: Paper gasket

Piston mounting direction: one arrow drawn perpendicular to the axis of the piston, figure on the top of the piston. It must be oriented in the direction of engine rotation during the connecting rod's downward stroke (see manufacturer's instructions or diagram).

It is essential to check the ring end gap of each piston ring before installing them on the pistons, according to the values ​​given by the manufacturer or in the supplied instructions.

During installation, the ring end gap must be evenly distributed around the piston circumference at 120°.

The entire kit is composed of 3/8"-24UNF and M10x100 fittings

This kit is composed of the following copper pipes:

- From the brake master cylinder to the Right Front Wheel

- From the brake master cylinder to the Left Front Wheel

- From the brake master cylinder to the rear distributor

- From the rear splitter to the right rear arm

- From the rear splitter to the rear left arm

-From the Right Rear arm to the Right Rear wheel

-From the Rear Left arm to the Rear Left wheel

• R4 (Billancourt Engine): Alternator belt - Ref 0854249800
• R5 Alpine (1223) / R5 alpine Turbo (122B): Water pump belt

• 4 spark plug wires + 1 coil wire
• 90° angled coil terminals
• Length of coil cable: 61cm
• Length of 2 spark plug wires: 26.5cm
• Length of 2 spark plug wires: 36.5cm
• We would like to point out that our spark plug wires are made with Ø 7mm silicone wire and a standard copper core (wire material), which means they are not protected against interference.
• If the vehicle is equipped with electronic accessories If you have sensitive equipment, such as a radio, tripmaster, monitor, or certain electronic ignition kits, interference or disruption may occur.