Internal throttle return spring retaining plate for WEBER DCOE 40 and DCOE 45 carburetor

• Inlet / outlet connection: BSP 1/2" x14 (x2)
• Threaded sleeve: male Ø3/4" - 16UNF and female Ø3/4" - 16UNF

Please note, the oil filter plate does not correspond to the original hoses and fittings. Provide for the replacement of these fittings and hoses.

• Suitable for WEBER 40DCOE and WEBER 45DCOE carburettors.
• Wire thickness 1 mm and wound length 33 mm.
• Number 50 on exploded view
• Also suitable for the following carburettors: 38 DCOE, 40 DCOE, 42 DCOE, 45 DCOE.

• Sold individually, 1 cover required per carburetor
• Number 4 on exploded view

• Overall Length: 236cm
• Sheath Length: 193.5cm
• Cable Length: 226cm

Our cables are made in France and meet the assembly and quality standards of original equipment (OE) cables from car manufacturers.

• Choke filter for WEBER 40DCOE and 45DCOE carburetors  
• Requires 1 piece per carburetor
• Part number 87 on exploded view
• Also suitable for: 35 DCNL, 36 DCNF, 36 DCNFA, ​​38 DCNL, 40 DCNF, 40 DCNL, 38 DCOE, 40 DCOE, 42 DCOE, 45 DCOE.

• Idle speed adjustment screw spring for WEBER 40DCOE and 45DCOE
• sold individually, ,eed 2 pieces for one carburettor
• Part number 47 on the exploded view
• Fits other WEBER carburettors, see below  

• Throttle control lever for TWO WEBER 40DCOE AND WEBER 45DCOE carburetors
• Allows carburetor synchronization
• Suitable for R8 Gordini, Alpine A110, Simca Rallye
• 8mm diameter ball joint