Cork and rubber gasket sheet to cut - Thickness: 2mm

For diaphragm clutch mechanism

• Suitable for WEBER 40 DCOE carburetor
• Tune extends from the carburetor: 15mm
• Carburetor mounting via stud and nut
• Mounting hole spacing: 66mm
• Allows the installation of high-performance filters (AVP48099 or AVP48100) and sock filters (AVP48103)
• Ideal for competition use

For installation with new generation venturis (Ref. AVP48084 or AVP48085), the spacer (AVP48087) is recommended

to fill the space between the auxiliary venturi and the carburetor body.

Ideal velocity stack for mounting an R5 Alpine engine with two Weber 40 DCOE carburetors in an Alpine A110 with a large chassis

• Paper gasket thickness: 1.6 mm
• Suitable for all 1565cc / 1596cc / 1605cc and 1647cc engines

• Sheet Dimensions: Length 50cm x Width 35cm
• Sheet Thickness: 1.2mm
• Ideal for making water seals, oil pumps, cylinder head cover gaskets, oil pan gaskets, and intake or exhaust manifold gaskets. Temperature limit: 400°C
• Material made of aramid fibers and mineral fillers bonded by a nitrile butadiene elastomer.

• Titan R0
• Diamètre : 7mm
• Longueur : 32mm
• Corps lisse : 9mm

• Suitable for WEBER 40DCOE carburetors (First and last generation)
• This spacer fills the gap between the 4.5 venturi outlet and the carburetor body.
• It allows the installation of screw-on aluminum velocity stacks (AVP48091 and AVP48092) or a installation without a velocity stack
• This spacer is necessary if you are using the 4.5 venturis (AVP48084 or AVP48085) without the 55mm push-in air intake velocity stacks (AVP48093)

Caution: Some carburetors have irregularities in their internal machining of the body. In this case, it may be necessary to make adjustments to certain spacers to precisely fit them to the carburetor bodies.