Complete engine gasket kit "Small bearing" (73mm bore) - 1289cc engine (Type 810) - R12 / A110 V85

• End cap for stop switch Ø 12.5mm
• Mounting using a long rod

• Suitable for copper tube Ø 3.5x6.35mm

This brake limiter replaces the original non-adjustable rear brake proportioning valve.

The limiter is not load-dependent (it does not vary according to the vehicle's load).

Its adjustment is manual, using the calibration screw. Adjustment can be made either statically, using brake pressure gauges and referring to the manufacturer's data, or dynamically (see description below).

Limiter specifications:

• Inlet thread (x1): 3/8-24UNF (Male cone)
• Outlet thread (x2): 3/8-24UNF (Male Taper)
• Mounting Screw Hole Diameter: Ø 8.5mm
• Limiter Adjustment Range: 5 turns
• Limiter delivered unadjusted (screw loosened): Rear brake pressure limited to maximum

• Sold with water pump gasket
• Distance between two pulley mounting bolts (Center-to-center):50mm
• Pulley mounting using x4 M8 bolts (Not supplied)

Suitable for:

• R8 and R8G
• Caravelle and Floride S
• Alpine GT4
• A110 (1300cc engine)
• Matra Djet (1300cc engine)

The high-flow water pump increases performance Cooling without any modifications. It installs without any modifications, directly in place of the original Renault or Alpine pump.