Complete right rear caliper Ø 38mm - remanufactured (mass cut aluminum)

• Thread (master cylinder side): M16x150
• Nozzle (rubber hose connection side): Ø 10mm

Suitable for:

• R4 / 4L: Front Brake
• R5 Alpine Atmo (1223) and Alpine Turbo (122B): Front Brake
• R8: Big Brake Installation: Front Brake
• R12 (All models): Front Brake
• R15 / R16 / R17 (All models): Front Brake
• A110: Big Brake Installation: Front Brake
• A310.4 / A310 V6 (Pre-1980): Front Brake
• Alpine GTA (V6 GT and V6 Turbo): Front Brake

Brake pads with a retaining stop (B in the diagram) must be installed with this stop positioned towards front (direction of wheel rotation)

• Sold with water pump gasket
• Distance between two pulley mounting bolts (Center-to-center):50mm
• Pulley mounting using x4 M8 bolts (Not supplied)

Suitable for:

• R8 and R8G
• Caravelle and Floride S
• Alpine GT4
• A110 (1300cc engine)
• Matra Djet (1300cc engine)

The high-flow water pump increases performance Cooling without any modifications. It installs without any modifications, directly in place of the original Renault or Alpine pump.

• Kit includes: 4 screws, 8 washers, and 4 nuts
• This kit allows you to install an aluminum shim on the pivot (right or left),
• 2 kits required per vehicle.

• Shim sold individually, 2 shims required to equip a front axle.
• In addition to the aluminum shim for attaching the front caliper, a caliper yoke is required (not available in the AVP catalog)
• WARNING: This assembly is specific. We remind you that some brake caliper yokes may not be compatible with the so-called "Big Brake" assembly.

It is mandatory to change the calipers in pairs (Right and left caliper)

Suitable for:

- Front brake for "Big front brake" type mounting: A110/R8G

- Rear brake for "Big Rear brake" type with hydraulic handbrake: A110/R8G

- Front brake: A310.4 (from chassis n°910 to end of series)

- Front brake: R16.TS