Stabilizer bar rubber - inner Ø 12mm

• Piston diameter: Ø 53 mm (Minimum) to Ø 125 mm (Maximum)
• Tool height: 75 mm
• Supplied with a square tightening wrench
• Ideal tool for installing pistons in the cylinder block

The central unit is connected as follows:

• The 12V power supply (+ battery) wire on the "X" or "+" terminal
• The Switch or stalk control wire on the "L" or "Z" terminal
• The repeater indicator light wire (LED) on the "P" terminal

• These bushings replace the original bushings; no modifications are required.

The central unit is connected as follows:

• The 6V power supply (+ battery) wire on the "X" or "+" terminal
• The Switch or stalk control wire on the "L" or "Z" terminal
• The repeater indicator light wire (LED) on the "P" terminal

Cap Dimensions:

• Inner Diameter: Ø 40mm
• Outer Diameter: Ø 42mm
• Height: 26.5mm

Also suitable for some R16 (R1150) models with rear drum brakes.