Rear trunk cylinder (Version with spoiler or wings) - A310 V6 (From 1981) and GT Pack - Ref 6000054855

Delivery in France only

• Does not absorb moisture, thus protecting brake systems from rust, which accumulates on wheel cylinders and destroys the brake pads after a few brake applications when the brakes are restarted in the spring.
• DOT 5 approved (not to be confused with DOT 5.1)

Directions for use:

• Before using this brake fluid, your system must be thoroughly bled, rinsed with rubbing alcohol, and dried.

• Need x6 gaskets to equip an engine
• Sold individually

• This ignition harness consists of 6 spark plug wires and 1 coil wire.
• We would like to point out that our spark plug harnesses are made with 7mm diameter, black silicone wires with a standard copper core, which means they do not have interference protection.
• If the vehicle is equipped with sensitive electronic accessories, such as radios, tripmasters, monitors, or certain electronic ignition kits, some interference or disruption may be observed.

Inlet and outlet Ø 6-8mm

• This ignition harness consists of 4 spark plug wires and 1 coil wire, each 7mm in diameter.
• It does not have interference suppression.

If the vehicle is equipped with sensitive electronic accessories, such as a radio, trip meter, monitor, or certain electronic ignition kits, interference or disruptions may occur.

• Coil wire length: 450mm
• Spark plug wire lengths: 350mm / 350mm / 350mm / 350mm

Ignition cables with copper core with interference suppression,

Copper is an excellent conductor However, it is very susceptible to corrosion. Therefore, the copper core of this type of cable harness is coated with tin. This tin layer protects the copper from oxidation.

The copper core is also coated with silicone rubber for increased durability and electrical insulation. The outer silicone rubber insulation can withstand temperatures up to 220°C and is also resistant to oil and gasoline splashes. Cables with a copper core do not have internal interference suppression.