- Sold with drill bit holder
- Includes 5 drill bits in each of the following sizes:
- 0.6mm
- 0.7mm
- 0.8mm
- 0.9mm
- 1.0mm
- 1.1mm
- 1.2mm
- 1.3mm
- 1.4mm
- 1.5mm
- 1.6mm
- 1.8mm
- 2.0mm
- 2.1mm
- 2.2mm
- 2.3mm
- 2.4mm
- 2.5 mm
- 2.6mm
- 2.8mm
- 3.0mm
- 3.2mm
Out of stock
Tool for adjusting float clearance 5 / 6mm
Reference:
48106
- Allows easy adjustment of the float with one side of the tool calibrated to 5mm and the other to 6mm.
- Allows direct action on the float tab thanks to a slot at the end of the tool
€24.00
(tax incl.)
Order before 1pm and enjoy same day shipping !
You may also like
- Allows control of nozzle calibration
- Graduation is 0.10 mm in 0.10 mm increments, with a minimum of 1.5 mm to 3.00 mm and a maximum of 1.5 mm.
In stock
- Allows control of nozzle calibration
- Graduation is 0.05 mm in 0.05 mm increments, with a minimum of 0.45 mm and a maximum of 1.5 mm.
In stock
- Allows easy adjustment of the float with one side of the tool calibrated to 8mm and the other side to 9mm.
- Allows direct action on the float tab thanks to a slot at the end of the tool.
In stock
Customers who bought this product also bought:
- Suitable for WEBER 40 DCOE carburetor
- Tune extends from the carburetor: 15mm
- Carburetor mounting via stud and nut
- Mounting hole spacing: 66mm
- Allows the installation of high-performance filters (AVP48099 or AVP48100) and sock filters (AVP48103)
- Ideal for competition use
For installation with new generation venturis (Ref. AVP48084 or AVP48085), the spacer (AVP48087) is recommended
to fill the space between the auxiliary venturi and the carburetor body.
Ideal velocity stack for mounting an R5 Alpine engine with two Weber 40 DCOE carburetors in an Alpine A110 with a large chassis
In stock
- This paste is suitable for petroleum-derived hydrocarbons (mineral oils, petroleum, fuel oil, leaded and unleaded gasoline, etc.), chlorinated solvents, diluted acids and bases
- Replaces or is used in combination with paper (fibered) gaskets
- Temperature resistance on gasket: -20°C to +100°C
- Pressure resistance: 6 bars at 70°C on 1" threaded fittings and 40 bars at 20°C on 1" threaded fittings
- Pressure application: 15min
In stock
- Suitable for WEBER 40DCOE and 45DCOE carburetors
- M5X22 screws
- Sold individually, requires 9 pieces for one carburetor
- Number 5 on exploded view
- Compatible with other WEBER carburetors, see below
In stock
In stock
In stock
- R4 (Billancourt Engine): Alternator belt - Ref 0854249800
- R5 Alpine (1223) / R5 alpine Turbo (122B): Water pump belt
In stock
- Sold individually, 1 cover required per carburetor
- Number 4 on exploded view
In stock