Steering ball joint - Reinforced version (M14x150) - A310.4 / A310 V6
- Ball Joint Thread: M14x150 (Left-Hand Thread)
- Ball Joint Thread: M14x125 (Right-Hand Thread)
- Tie rod end sold individually
The AVP7344 tie rod end is not compatible with the original A310 V6 M12x100 mounting, but must be assembled with the AVP7606 reinforced tie rod.
 - A310.4 / A310 V6&media=https://www.arnaudventouxpieces.com/3908-large_default/steering-ball-joint-m14x150-only.jpg){kind=link}
- Tie rod/ball joint thread: M14x150(Left-hand thread)
- Tie rod sold individually
- It is possible to install it on an A310.4 using the AVP7609 adapter to replace the original "fork"-type tie rods
The AVP7606 tie rod is not compatible with the original A310 V6 M12x100 mounting, but must be assembled with the AVP7344 reinforced tie rod end.
- The reinforced tie rod and ball joint kit (M14x150) replaces the original M12x100 tie rods and ball joints without any modification.
- It is possible to install it on an A310.4 using the AVP7609 adapter to replace the original "fork" tie rods.
- Tie rod sold individually.
Dimension of the axis of the upper fixing bolt at the support of the 1st washer
- This ignition harness consists of 6 spark plug wires and 1 coil wire.
- We would like to point out that our spark plug harnesses are made with 7mm diameter, black silicone wires with a standard copper core, which means they do not have interference protection.
- If the vehicle is equipped with sensitive electronic accessories, such as radios, tripmasters, monitors, or certain electronic ignition kits, some interference or disruption may be observed.
Accelerator cable compatible with A310/VG 1647CC
-
- Overall length: 309.5 cm
- Sheath length: 268 cm
- Cable length: 306 cm
Our cables are made in France and meet the assembly and quality standards of original equipment (OEM) cables from automotive manufacturers.
- Kit consisting of 4 large springs, 2 small springs, and 4 retaining clips.
- Kit for Bendix setup or large brake setup (Ø 48mm)
- One kit required per pair of brake calipers.
- Renault / Alpine OE Ref: 0855832300 + 0855832400 + 7701001447
For setups with cast iron caliper brackets, use two identical large springs per caliper.
For stamped steel caliper brackets, use one small spring on the inside and one large spring on the outside.
Suitable for:
- R4
- R8G (Large brake setup)
- Renault 16
- A110 (Large brake setup)
- A110 (SC / SI / SX)
- A310 4 (All models)
- A310 V6 (Early version - 3-bolt wheels)