Stainless steel pivot pin wedging washer - Thickness 0.5mm - 1st and 2nd model

• Special Premium Quality graphite for clutch release bearings
• Important: The release bearing clamping screw must be placed on the side opposite the fork
• It is possible to keep the release bearing and replace only the graphite ring if worn.
• Depending on the diameter of the return spring, it may be necessary to re-drill the release bearing mounting.
• It is recommended to soak the release bearing in warm engine oil and then wipe it dry before installation to avoid squeaking noises

Dimensions:

- Length 145mm

- Interior Ø 46mm and Ø of the rod 10mm

• Mounting center distance: 44.5mm
• Thickness: 5mm

Bandjo fixing screw: Ø3/8" - 24UNF

• Crimp Diameter: Ø 70.9mm
• Thickness: 1.45mm (Original dimension)
• Material: Multi-layer with steel crimp

Sold with two keys