Brass Cable Clamp for Starter Cable

• This ignition harness consists of 4 spark plug wires and 1 coil wire, each 7mm in diameter.
• It does not have interference suppression.

If the vehicle is equipped with sensitive electronic accessories, such as a radio, trip meter, monitor, or certain electronic ignition kits, interference or disruptions may occur.

• Coil wire length: 450mm
• Spark plug wire lengths: 350mm / 350mm / 350mm / 350mm

Ignition cables with copper core with interference suppression,

Copper is an excellent conductor However, it is very susceptible to corrosion. Therefore, the copper core of this type of cable harness is coated with tin. This tin layer protects the copper from oxidation.

The copper core is also coated with silicone rubber for increased durability and electrical insulation. The outer silicone rubber insulation can withstand temperatures up to 220°C and is also resistant to oil and gasoline splashes. Cables with a copper core do not have internal interference suppression.

• Suitable for older generation WEBER 40DCOE carburetors (the bearing surfaces differ from the shafts of modern versions)
• Caution: The throttle plates or flaps must be mounted using flat-head screws. (AVP48052)
• The mounting hole for the accelerator pump control must be drilled by the user, depending on the type of pump control.
• Overall shaft length: 180mm
• Thread diameter at shaft ends: M7
• Part number 85 on the exploded view

• Brake master cylinder: 4CV (2nd Model) / Dauphine / Floride / Alpine A108
• Clutch transmitter: Matra Djet

• Delivery only in France