Pair of "non-aerostable suspension" rear shock absorbers - Dauphine from 01/1967 until the end ... (Dauphine Gordini included)

Flexor Specifications:

• • Mounting hole spacing:4 x 50.50 mm
  • Mounting hole diameter: Ø 8.4 mm
  • Center hole diameter:Ø 10.50 mm
  • Flexor thickness: 11 mm
  • Material:Rubber flexor with metal reinforcement
  • Supplied with 4 x M8 x 20 mm screws and 4 x nylock nuts

For some assemblies with a center screw, replacing this screw with a socket head cap screw (SHCS) or modifying the flexor may be necessary.

Axle specifications:

• Smooth shaft diameter: Ø 16mm
• Thread diameter: M14x200 (right-hand thread)
• Smooth shaft length: 15.8cm
• Overall length: 25.2cm
• Supplied individually, without nut

Suitable for:

• 4CV: Post-1956
• Dauphine
• R8 / R8S / R8G
• Caravelle
• Floride / Floride S
• A106 / A108
• A110 (All models)
• Matradjet

These mounts improve the reliability and stability of the gearbox, whether for daily driving or competitive use.

These mounts are direct replacements for the original ones; no modifications are required.

Installation advice:

• When installing the side mounts, ensure the two metal plates of the mount are perfectly parallel to each other to prevent premature wear or tearing of the mount.
• Depending on the gearbox and mounting bracket models, spacing with one or two thick washers (+/- 2 mm per washer) may be necessary between the mount and the gearbox at the mounting studs. On other models, no spacing is required; installation can be performed without applying stress to the assembly.

Ring Size:

• Inner Diameter: Ø 21mm
• Outer Diameter: Ø 24mm
• Height: 30mm

Suitable for:

• 4CV (2nd Assembly): From 1956
• Dauphine / Floride
• Alpine A106 / A108

• Inner diameter of the rubber washer: Ø 95mm
• Outer diameter of the rubber washer: Ø 125mm