In stock
Kit of x5 copper brake pipes (premium quality) - Fitting for original braking system - A110 all models (except 1600 SC/SI/SX)
Reference:
6408
The entire kit is made up of 3/8" -24UNF fittings
This kit is made up of the following copper pipes:
- from the brake master cylinder to the Front Right wheel
- from the brake master cylinder to the Front Left wheel
- from the brake master cylinder to the distributor or rear three-way connection
- from the three-way connection or rear distributor to the right rear wheel
- from the three-way connection or rear distributor to the left rear wheel
€134.00
(tax incl.)
Order before 1pm and enjoy same day shipping !
You may also like
- Thread diameter: Ø 3/8" - 24UNF (+/- 9.52mm)
- Nut inner diameter: Ø 5.10mm
- Overall length: 19mm
- Length under head: 14mm
- Cone: Concave / Female
- Renault / Alpine OE part number: 6035324 / 0603532400 / 7700523490
Out of stock
Customers who bought this product also bought:
- Washer sold individually
- One washer allows the centering of a brake disc on the pivot
- 2 washers are required to equip a front or rear axle.
In stock
In stock
In stock
Kit specifications (Tie rods / Ball joints and boots):
- Ball joint taper diameter (Steering knuckle side): Top of taper Ø 11mm / Bottom of taper Ø 12mm
- Ball joint taper stud thread diameter: M10 x 1.25 (right-hand thread)
- Ball joint stud thread diameter (into tie rod): M14 x 1.50 (right-hand thread)
- Tie rod thread diameter (into steering rack): M12 x 1.00 (right-hand thread)
- Minimum length of tie rod/ball joint assembly: 26 cm (measured from the contact point against the steering rack to the center of the ball joint stud on the steering knuckle side)
- Maximum adjustment of the tie rod/ball joint assembly: 29 cm (measured from the contact point against the steering rack to the center of the ball joint at the steering knuckle end)
- Includes: 2 steering rack boots, 2 steering ball joints (with nuts and locknuts), and 2 steering tie rods.
Suitable for:
- R8 (All models)
- Caravelle / Floride S
- A110 (All models) / Alpine GT4
- Matradjet
This adjustable steering kit replaces the original "fork-type" steering tie rods.
To install the adjustable tie rods, you must remove the steering rack eyelet bushing and replace the steering rack boots with the specific AVP4620 boots (included in the kit).
In stock
In stock
 - Fitting for original braking system - A110 all models (except 1600 SC/SI/SX)&media=https://www.arnaudventouxpieces.com/8485-large_default/kit-of-x5-copper-brake-pipes-premium-quality-fitting-for-original-braking-system-a110-all-models-except-1600-scsisx.jpg){kind=link}
Engine gasket kit specifically for small bearings: including a crankshaft oil seal (flywheel side) Ø 70x90x10mm and an oil pan gasket (small bearing).
Suitable for:
- R12 L / TL / TS: 1289cc engine (Type 810)
- R15 TL / GTL: 1289cc engine (Type 810)
- Alpine A110 V85: 1289cc engine (Type 810)
- Estafette: 1289cc engine (Type 810)
- OE Ref Renault / Alpine:7701452153
In stock