Hollow valve lifter

• Sold with 3 fixing screws and the oil seal (Ø 17x30x7mm)
• Guide to be mounted when replacing a clutch with a graphite thrust bearing with a modern diaphragm clutch
• It is necessary to drill and tap in the clutch bell to mount the adaptation guide.
• Mounting instructions supplied with the kit

Suitable for:

- R8.G (R1134 / R1135) from 10/1964 to 1974

- Alpine A110: 1100cc / 1300cc / 1600cc / SC and SX (with Alpine A310 rear axle)

- Alpine GT4 / Matradjet

AVP recommends the reinforced gearbox side silentblocks Ref 4305, for reasons of reliability and ease of assembly.

• Special Premium Quality graphite for clutch release bearings
• Important: The release bearing clamping screw must be placed on the side opposite the fork
• It is possible to keep the release bearing and replace only the graphite ring if worn.
• Depending on the diameter of the return spring, it may be necessary to re-drill the release bearing mounting.
• It is recommended to soak the release bearing in warm engine oil and then wipe it dry before installation to avoid squeaking noises

Suitable for engines:

• Engine Type 670-05: Dauphine Gordini (R1093 / R1095) / Estafette / Floride (R1092) / A106 / A108
• Engine Billancourt Type 680-... and 800-...: R4 / 4L / R5

Valve with low keyway

Valve sold individually