Starter heat shield with thermal protection - 1600cm³ engine (1605cm³ and 1647cm³)

• Supplied with self-adhesive thermal protection to be applied to the most suitable side depending on the installation.
• OE Renault Ref: 6000048783 / 6001005622

• Tie rod/ball joint thread: M14x150(Left-hand thread)
• Tie rod sold individually
• It is possible to install it on an A310.4 using the AVP7609 adapter to replace the original "fork"-type tie rods

The AVP7606 tie rod is not compatible with the original A310 V6 M12x100 mounting, but must be assembled with the AVP7344 reinforced tie rod end.

• CV joint locking pin, one inside the other
• Pin dimensions: Ø 4x50mm and Ø 6x50mm
• Sold in sets of 2 for one side
• Ref OE Renault / Alpine:7703067023 + 7703067135

Suitable for:

• Alpine A310 V6
• Alpine GTA: V6 GT (D500) and V6 Turbo (D501 and D502)
• Alpine A610 (D503)
• Renault R30

• Center distance between carburetor and intake pipe : 110mm and 70mm
• Flanges with tapping for a vacuum
• Flanges to be assembled directly on the carburetors, the seal is ensured by O-rings (delivered with 4 O-rings)

• A hose needs to be cut at the location of the heating tap.