Front or rear brake lining set with rivets - width 30mm x Ø228mm

Suitable for:

• Dauphine (R1090 / R1091)
• Floride
• Alpine A108 (To be cut)

• Overall length: 198.5cm
• Sheath length: 67cm x 2
• Cable length: 196cm

Our cables are made in France and meet the assembly and quality standards of original equipment (OEM) cables from automotive manufacturers.

• Overall length: 283.5 cm
• Sheath length: 231 cm
• Cable length: 272.5 cm

Suitable for:

• Alpine A108 and GT4
• Dauphine
• Floride

Our cables are made in France and meet the assembly and quality standards of original equipment (OEM) cables from automotive manufacturers.

For engine with 4-outlet water pump.

Kit sold without valve stem seals (AVP1012), without copper base seals and without the timing case oil seal (AVP1029).

• Special Premium Quality graphite for clutch release bearings
• Important: The release bearing clamping screw must be placed on the side opposite the fork
• It is possible to keep the release bearing and replace only the graphite ring if worn.
• Depending on the diameter of the return spring, it may be necessary to re-drill the release bearing mounting.
• It is recommended to soak the release bearing in warm engine oil and then wipe it dry before installation to avoid squeaking noises