Boot bottom molded seal - Ref 0821539900

• Sold individually
• Width: 28mm
• Length: 39mm
• Height: 25mm

F4 and F6 rear door seal

The license plate attaches directly to the bottom of the hood.

This hood is designed for rectangular front turn signals and features flat hood reinforcements.

It is recommended to perform a dry fit of all body panels to ensure proper alignment.

Some adjustments may be necessary.

--> Feel free to contact us for shipping conditions and rates!

• This ignition harness consists of 4 spark plug wires and 1 coil wire, each 7mm in diameter.
• It does not have interference suppression.

If the vehicle is equipped with sensitive electronic accessories, such as a radio, trip meter, monitor, or certain electronic ignition kits, interference or disruptions may occur.

• Coil wire length: 550mm
• Spark plug wire lengths: 300mm / 300mm / 350mm / 350mm

This type of harness includes a fiberglass core supporting a conductive and magnetic silicone sheath around it around which a stainless steel wire is wound.

This winding works on the principle of a coil; an induced voltage is created by the electromagnetic flux generated by the passage of high voltage through the core of the cable.

The magnetic field fluctuates within the cable, while the stainless steel wire wound around it like a coil absorbs or compensates for the energy generated by the cable. Ignition leads equipped with an inductive resistor are wrapped with two layers of silicone and a layer of fiberglass. The internal silicone insulation ensures durability and protects against high voltages.

The fiberglass fabric increases the mechanical strength of the cable. The exterior silicone rubber insulation withstands temperatures up to 220°C and is resistant to hydrocarbons.