Set of 4 wooden spacers for raising the front under-seat runners – R8 Gordini

Flexor Specifications:

• • Mounting hole spacing:4 x 50.50 mm
  • Mounting hole diameter: Ø 8.4 mm
  • Center hole diameter:Ø 10.50 mm
  • Flexor thickness: 11 mm
  • Material:Rubber flexor with metal reinforcement
  • Supplied with 4 x M8 x 20 mm screws and 4 x nylock nuts

For some assemblies with a center screw, replacing this screw with a socket head cap screw (SHCS) or modifying the flexor may be necessary.

Maintenance-free ring

• This kit contains an M9 adjustment screw nut and an M8 nut
• To identify a caliper with a square or round joint, refer to the symbol indicated on the caliper casting.
• A square symbol indicates a square joint, while a circle symbol indicates a round joint.
• It is essential to preserve and replace the joint that originally came with the caliper.
• We recommend checking the symbol displayed on each caliper, as a vehicle may have calipers from different origins, some with square joints and others with round joints.
• It is not recommended to mix calipers on the same axle, as this can lead to the risk of them slipping during braking.

• Primary winding resistance: 3.1 ohms
• Secondary winding resistance: 9200 ohms
• Coil compatible with electronic ignition kits ref. AVP4798 and AVP4799

• End cap for stop switch Ø 12.5mm
• Mounting using a long rod

Supplied with self-adhesive thermal protection to stick on the most suitable side depending on the assemblies.