Original silencer 2 outputs - A110 1600 VC and VB (n°17700 to...) - Ref 6000001241

Inlet and outlet Ø 6-8mm

• Distance between two pulley mounting screws: 37mm
• Pulley mounting using 3 x M8 screws (Not supplied)
• The heater outlets can be plugged using two 16mm diameter rubber plugs and one 10mm diameter plug
• Water pump sold with water pump gasket, plate gasket, and plate

Delivery in France only

• Does not absorb moisture, thus protecting brake systems from rust, which accumulates on wheel cylinders and destroys the brake pads after a few brake applications when the brakes are restarted in the spring.
• DOT 5 approved (not to be confused with DOT 5.1)

Directions for use:

• Before using this brake fluid, your system must be thoroughly bled, rinsed with rubbing alcohol, and dried.

• Cooling fan: Pusher or Puller
• Universal Spal connector (requires modification depending on specific vehicle wiring)
• Observe correct wiring polarity for fan rotation:
• Fan in puller mode: Red (+ Battery) / Black (- / Ground)
• Fan in pusher mode: Red (- / Ground) / Black (+ Battery)
• Fan supplied as a standalone unit; mounting or fixing kit not included.
• See fan dimensions in photo #2