Front or Rear Brake Pad Sets "Mintex MRM1802" - Competition Type (For Small Brake Mounting)

• Glass bowl Ø 67mm
• Filter element: Interchangeable paper cartridge
• One inlet: dual size 6 and 8mm
• One outlet: dual size 6 and 8mm
• Regulation pressure: Regulation range from 0 to 0.6 bar
• Compatible with fuel SP95 / SP98 / E85
• Pressure adjustment via the upper screw which acts directly on the membrane

4CV: Drum brake (From 06/1953 until end of series)

Alpine A106: Drum brake

Dauphine (All models): Disc brake

Caravelle / Florida: Disc brake

R10 / R8 (All models): Disc brake

Alpine A110 and GT4: Disc brake

Matradjet: Disc brake 

This kit contains x4 hoses Ø 3/8"-24UNF - Length of hoses 32cm and 26cm

• Overall Length: 225cm
• Sheath Length: 82.5cm
• Rod Length: 113cm
• Cable Length: 111cm

Please note: for installation on a Renault Caravelle, we have noticed that some versions have a longer rigid rod. The rod will need to be extended by a few centimeters for installation.

Our cables are made in France and meet the assembly and quality standards of original equipment (OE) cables from car manufacturers.

• Overall length: 245.5cm
• Sheath length: 193.5cm
• Cable length: 235cm

Suitable for:

• A110.1100 (VA and VB)
• A110.1300 (VA and VB)
• A110.1300 VC (V85)

Our cables are made in France and meet the assembly and quality standards of original equipment (OEM) cables from automotive manufacturers.

• This kit contains an M9 adjustment screw nut and an M8 nut.
• To identify a caliper with a square or round seal, refer to the symbol indicated on the caliper casting.
• The "square" symbol indicates the presence of a square seal, while the circle symbol indicates the presence of a round seal.
• It is essential to replace the same type of seal (round or square) according to the symbol on the caliper.
• We recommend that you Check the symbol displayed on each caliper, as a vehicle may have calipers of different origins, some with square joints and others with round joints.
• It is not recommended to mix calipers on the same assembly, as this can lead to the risk of skewing during braking.

Sold without adjusting screws or handbrake lever. Caliper equipped with a square seal.

Suitable for:

• Dauphine / Dauphine Export (Disc brakes)
• R8 / Caravelle / Floride S
• A110 (Small brake setup)
• Matra Djet: Right Rear Brake Caliper

This lighter is suitable for:

- R8G / A110 (1108cc / 1255cc / 1296cc)

Kit to be used with a primary resistance coil between 2.5 and 3.5 ohms

Compatible with AVP4708 and AVP4715 coils